Underfloor heating mat DEVI 150T 750W 0.5x10m — 750 W, 0.5 m width, 10 m length

DEVI 150T underfloor heating mat 750 W, 0.5 m x 10 m is a self-adhesive electric heating mat designed to deliver consistent surface warmth for rooms, bathrooms and kitchens. The mat features a fixed wattage of 750 W and a compact 0.5 m width that makes it suitable for laying under tile, stone or other floor coverings where even heat distribution and a low-profile installation are required. It is intended for embedding in thin-set adhesive or levelling compound in both retrofit and new-build installations.

Advantages

The DEVI 150T mat provides stable, evenly distributed heat across the floor surface with a fixed power output that simplifies electrical planning. Its self-adhesive backing keeps the cable grid in place during installation, reducing adjustment time. The narrow 0.5 m width allows accurate fitting around fixtures and in smaller rooms, while the mat construction is compatible with common floor coverings and standard thin-set or levelling compounds.

Suitable for

• Bathroom floor heating under tile or stone
• Kitchen or utility room retrofit heating
• Heated floors in small to medium-sized rooms or zoned areas
• Embedding in thin-set mortar or levelling compound beneath floor finishes

Key specifications

• Total heating power: 750 W
• Mat width: 0.5 m
• Mat length (floor coverage): 10 m
• Fixed wattage configuration for consistent output
• Self-adhesive backing for secure placement during installation
• Suitable for embedding in thin-set adhesive or levelling compound

How to use

Prepare a clean, level subfloor and plan the mat layout avoiding fixed installations and obstructions. Roll out the self-adhesive mat and cut the mesh to turn, taking care not to cut the heating cable. Secure the mat to the substrate, adjust spacing if required and embed the mat in a suitable thin-set adhesive or levelling compound following the compound manufacturer’s instructions. Connect the heating cable to the thermostat and electrical supply only after completing the floor covering and in accordance with local electrical regulations; final electrical connections should be made by a qualified electrician.

Lietošanas ieteikumi

To ensure reliable performance, test the heating circuit before embedding and again after completing the floor finish. Use an appropriate floor sensor and thermostat matched to electric underfloor heating systems to maintain desired room temperature and energy efficiency.