Outdoor UTP Cat6 Network Cable DS-IT DC-OUT-60-600 — 60 m, 100% Copper, Black

DS-IT DC-OUT-60-600 is an outdoor UTP Cat6 network cable supplied in a 60 m length and fitted with 100% copper conductors. The cable is designed for Ethernet installations that require the performance characteristics of Cat6 for reliable data transmission. Its black outer sheath is intended for exposed outdoor runs, supporting LAN, PoE and structured cabling in residential and commercial environments where a weather-resistant, non-shielded Cat6 solution is appropriate.

Advantages

The cable uses full copper conductors to maintain consistent signal integrity and lower resistance compared with copper-clad alternatives. As an outdoor-rated Unshielded Twisted Pair (UTP) Cat6 cable, it balances standard Cat6 performance with a construction suitable for above-ground or sheltered outdoor installations. The 60 m length on a single reel reduces the need for splicing in many typical runs and simplifies installation planning.

Suitable for (tasks / use cases)

• Outdoor or exposed Ethernet runs between buildings or to external network devices
• LAN backbone and horizontal cabling where Cat6 performance is required
• Power over Ethernet (PoE) connections to cameras, access points and IoT devices
• Residential and light commercial structured cabling installations

When it may not be suitable

This is an unshielded (UTP) Cat6 cable, so it may not be suitable in environments with high electromagnetic interference where shielded cable (STP/FTP) would provide better protection. The product is intended for outdoor-exposed runs but may not be appropriate for direct burial unless additional protective conduit or a burial-rated jacket is used. For runs longer than the recommended Ethernet distance for Cat6, a network extender or active equipment should be considered.

Key specifications

• Cable category: Cat6 (Unshielded Twisted Pair)
• Conductor material: 100% copper
• Length: 60 m
• Colour: Black sheath
• Intended application: Outdoor/exposed Ethernet and structured cabling
• Supported services: Ethernet, PoE

How to use

Measure the required run and route the 60 m cable along the intended path, avoiding sharp bends and areas of potential mechanical damage. Terminate both ends with compatible RJ45 Cat6 connectors or keystone jacks, following standard T568A or T568B wiring schemes. If the cable will be exposed to direct sunlight or mechanical stress, secure it with UV-resistant clips or conduit and ensure proper drip loops to prevent water ingress at terminations. Test the link with a cable tester or network tester after installation to confirm continuity, pair integrity and performance.

What to consider before purchase

• Whether a shielded cable is required for high-interference environments
• If direct burial is intended; consider conduit or burial-rated alternatives
• Required termination type and compatibility with existing connectors or patch panels
• Maximum run length for Cat6 Ethernet and any need for active equipment or extenders

Usage recommendations

For reliable outdoor installations, plan cable routes that minimise exposure to mechanical damage and UV stress, use appropriate mounting hardware or conduit, and complete post-installation testing to verify Cat6 performance and PoE delivery.