Patch Cable DS-IT CAT6a U/UTP 100% Copper 0.15 m White (DC-U6A2-001)

DS-IT CAT6a U/UTP patch cable, 0.15 m in white, is a compact network jumper designed for short, high-performance Ethernet connections. With 100% copper conductors and unshielded twisted-pair construction, this cable supports Gigabit and 10 Gigabit Ethernet links while minimizing insertion space in dense racks or patch panels. The short length reduces excess slack and helps maintain tidy cable runs in server rooms, network closets, and workstation setups.

Advantages

The cable delivers low electrical resistance and consistent pair geometry through its 100% copper conductors, offering reliable signal transmission for high-speed data. U/UTP construction provides a balance of performance and flexibility, making the cable easy to route in confined spaces. Its short 0.15 m length is practical for direct patching between adjacent ports and for minimizing cable clutter in compact installations.

Suitable for

• Patching between adjacent ports on switches or patch panels
• Short switch-to-switch or switch-to-server connections in dense racks
• Compact network cabinets, server rooms, and workstation cable management
• Environments requiring high-speed Gigabit and 10 Gigabit Ethernet links over short distances

When it may not be suitable

This 0.15 m cable is not intended for long-distance runs or situations where additional slack is required for routing around obstacles. Because it uses unshielded twisted-pair construction, it is not optimized for environments with high electromagnetic interference where shielded cables would provide better protection.

Key specifications

• Cable category: Cat6a
• Length: 0.15 m
• Conductor material: 100% copper
• Construction: U/UTP (unshielded twisted pair)
• Connector type: RJ45 connectors (both ends)
• Supported speeds: Gigabit Ethernet and 10 Gigabit Ethernet
• Color: White

How to use

Connect one RJ45 end to the source device and the other to the destination port, ensuring plugs are fully seated until the latch clicks. Use this short patch cable to link adjacent ports on the same patch panel or switch, or to make direct switch-to-server connections when minimal cable length is required. Verify link status on network devices after connection and avoid tight bends or strain on the cable and connector to maintain signal integrity.

What to consider before purchase

• Required cable length and whether 0.15 m is sufficient for your layout
• Whether unshielded construction meets the electromagnetic environment of the installation
• Compatibility with RJ45 ports and the required Ethernet speed (up to 10 Gbps)
• Color preference for cable management and identification

Usage recommendations

For best results, use this DS-IT CAT6a 0.15 m patch cable for direct adjacent-port connections and short patching needs in dense racks. Avoid routing near heavy sources of electromagnetic interference; if shielding is necessary, select a shielded cable variant.