Patch Cable DS-IT CAT6a U/UTP 100% Copper, 0.15 m, Red

DS-IT CAT6a U/UTP patch cable, 100% copper conductors, 0.15 m length and red outer jacket. This short patch cable is intended for high-speed Ethernet connections in tight rack or desktop environments where a compact, reliable link is needed. It meets CAT6a performance requirements to support 10 Gigabit Ethernet over short distances and is suitable for use between ports, patch panels and switches where minimal cable slack is desirable.

Advantages

The U/UTP construction with solid 100% copper conductors offers stable signal transmission and reduced attenuation compared with lower-quality materials. The 0.15 m length minimises cable clutter in dense patching areas and short interconnects, while the red jacket provides clear visual identification for network organisation or fault tracing. Its CAT6a performance rating ensures compatibility with 10 Gigabit Ethernet equipment where short patch leads are required.

Suitable for

• Patching between switch ports and patch panels in racks
• Short connections on desktop network devices
• Organised cable runs where colour coding is used for identification
• Environments requiring CAT6a performance for 10 Gigabit links over short distances

When it may not be suitable

This 0.15 m patch cable is not suitable for long-distance runs or for installations that require flexible cables to bridge larger gaps between equipment. It is also not intended as an in-wall or conduit-rated cable unless specifically tested and approved for such installations.

Key specifications

• Category: CAT6a performance
• Construction: U/UTP (unshielded twisted pairs with overall unshielded jacket)
• Conductor material: 100% copper
• Length: 0.15 m
• Colour: Red
• Intended use: Patch cable for Ethernet networking (short links)

How to use

Plug one RJ45 connector into the port on your network switch, router or patch panel and the other connector into the corresponding device port. Use this short cable to make tidy connections in patch panels, between adjacent switch ports, or to connect equipment in racks where minimal slack is preferred. Ensure connectors are fully seated and test the link speed and connectivity after installation to confirm CAT6a performance.

What to consider before purchase

• Required cable length and whether 0.15 m is sufficient for your layout
• Compatibility with your network equipment for 10 Gigabit operation
• Whether an in-wall or plenum-rated cable is needed for permanent installations
• Colour-coding needs for identification in your network infrastructure

Usage recommendations

For best results use the DS-IT CAT6a 0.15 m patch cable for short, direct connections in racks and patch panels; avoid excessive bending near the connectors and keep the cable free of sharp kinks to maintain signal integrity.