Circuit breaker 3-pole EATON xPole Home HN-C63/3 C63A 6kA AC (MPN 194897)

The EATON xPole Home HN-C63/3 is a three-pole overcurrent circuit breaker designed for residential and light commercial distribution boards. It provides C characteristic tripping with a rated current of 63 A and a short-circuit breaking capacity of 6 kA (AC). The device is intended for protecting three-phase supply circuits from overload and short-circuit conditions and is compatible with standard DIN-rail installations.

Advantages

The breaker offers a balance of sensitivity and durability through its C tripping characteristic, suitable for circuits with moderate inrush currents. With a 63 A rated current and 6 kA breaking capacity, it ensures reliable interruption of fault currents in typical household and small commercial installations. Its three-pole design allows simultaneous disconnection of all phases, helping to maintain system safety and reduce risk of phase-to-phase faults.

Suitable for

• Protection of three-phase supply lines in residential distribution boards
• Light commercial electrical panels and small workshops
• Circuit protection for motors, heating circuits and distribution feeders with moderate inrush
• DIN-rail mounted switchboards and modular panel installations

Key specifications

• Poles: 3-pole
• Tripping characteristic: C characteristic (moderate inrush tolerance)
• Rated current: 63 A
• Short-circuit breaking capacity: 6 kA (AC)
• Mounting: Standard DIN-rail compatible
• Application: Overload and short-circuit protection for three-phase circuits

How to use

Install the three-pole breaker on a standard DIN-rail inside the distribution board according to applicable electrical regulations. Connect each phase conductor to its respective pole and ensure proper tightening of terminals. Verify the breaker rating matches load and upstream/downstream protective devices. After installation, switch the device on and perform functional checks under no-load conditions before energising the protected circuits. Any wiring, commissioning or maintenance should be performed by a qualified electrician.

Usage recommendations

Use this breaker where a C characteristic is appropriate — for circuits with moderate inrush currents such as small motors and consumer loads. Confirm coordination with upstream protection and the 6 kA breaking capacity is sufficient for prospective short-circuit currents in the installation. Regular visual inspections and periodic testing following local standards will help maintain reliable protection.