Fibre optic cable EFB Elektronik O0318.15

The EFB Elektronik O0318.15 is a 15 m OM4 fibre optic patchcord with SC connectors on both ends, designed for high-bandwidth structured cabling installations. It follows international standards for structured cabling and serves as a short, direct connection between passive interfaces and active device ports. The cable features a 62.5 µm core and is intended for reliable data transmission in data centers and other environments requiring low attenuation and good signal integrity.

Advantages

The fibre optic patchcord is reinforced with aramid yarn for improved tensile strength and long-term stability. The LSZH sheath is halogen-free and flame-retardant, compliant with IEC-60754-2, IEC-60332-1 and IEC-61034. Connectors meet quality grades B/2 for singlemode and A/1 for multimode according to IEC-61753 series, and each cable is 100% tested and supplied with an individual test protocol. The use of OM4 multimode fibre supports high data rates and extended reach compared with lower multimode grades.

Suitable for

• Data centre interconnects and patch panels
• High-bandwidth enterprise networks
• Server-to-switch and switch-to-switch short links
• Structured cabling backbones and horizontal runs

Key specifications

• Brand: EFB Elektronik
• Model / MPN: O0318.15
• EAN: 4049759065232
• Length: 15 m
• Fibre type: OM4 multimode (core diameter indicated in source: 62.5 µm)
• Connector type: SC — SC (both ends)
• Sheath: LSZH (halogen-free, flame-retardant) compliant with IEC-60754-2, IEC-60332-1, IEC-61034
• Reinforcement: aramid yarn for tensile resistance
• Quality & testing: 100% checked with individual test protocol; connector grades B/2 (singlemode) and A/1 (multimode) per IEC-61753

How to use

Install the fibre optic patchcord by inserting the SC connectors into the corresponding SC ports on the devices or patch panels until they click into place. Route the cable following standard bend-radius recommendations to avoid tight bends or kinks, and secure it using appropriate cable management to prevent strain on the connectors. For multimode links, ensure both ends use compatible OM4 components and check polarity and connector cleanliness before powering equipment.

Usage recommendations

Handle connectors by the housing, keep endfaces clean and protected with dust caps when not in use, and perform end-to-end verification using the supplied test protocol or an optical loss meter after installation to confirm link performance.