Circular saw blade EINHELL HM 254 x 30 mm, 3.2 mm kerf, 48 teeth — for sliding crosscut/miter saws and table saws

The EINHELL circular saw blade 254 x 30 mm, 3.2 mm plate thickness with 48 carbide-tipped teeth is a replacement blade supplied as one piece. Designed for use with compatible Einhell saws as well as other machines with a 30 mm arbor, this blade is intended for general woodworking tasks including crosscuts, rip cuts and panels. Its 48-tooth geometry balances cutting speed and surface finish while the carbide tips extend working life and maintain edge sharpness for repeated use in workshop, construction and home improvement applications.

Advantages

The carbide-tipped teeth provide sustained sharpness and consistent cutting quality under frequent use. The 48-tooth configuration delivers fine, accurate cuts with reduced tear-out and a smoother edge suitable for visible surfaces. A 3.2 mm plate thickness increases rigidity during cutting, reducing vibration and blade wander for improved accuracy on sliding crosscut saws, miter saws and table saws.

Suitable for

• Crosscutting and ripping of softwoods and hardwoods
• Cutting laminated panels, veneered boards and plywood
• Fine woodworking where reduced chipping and smooth finish are required
• Use with sliding crosscut saws, miter saws and table saws with a 30 mm arbor

Key specifications

• Diameter: 254 mm
• Bore (arbor) diameter: 30 mm
• Blade plate thickness: 3.2 mm
• Number of teeth: 48
• Tooth type: carbide-tipped
• Primary material suitability: solid wood and wood-based panels

How to use

Fit the blade to a compatible saw with a 30 mm arbor following the machine manufacturer's installation instructions and ensuring the rotation direction marking matches the saw. Secure the flange and arbor nut to the recommended torque, check blade runout and alignment before commencing cuts. Set appropriate blade height, fence or miter angle for the required cut. When cutting laminated or veneered panels, consider using a sacrificial backing board or perform a scored starter cut to minimize edge chipping. Observe all safety precautions including eye, ear and respiratory protection and disconnect power before changing the blade.

Usage recommendations

Use steady, moderate feed rates to let the carbide tips cut efficiently without forcing the blade. For best surface finish on veneered or laminated materials, position the workpiece according to your saw type (face side down on table saws or face side up on sliding crosscut and miter saws as applicable). Inspect the blade regularly for chipped or dull teeth and replace the blade when cutting quality declines or damage is observed to maintain safety and performance.