PoE Injector electro base TAM01GT01GT-75W 75W power supply for network devices

The electro base TAM01GT01GT-75W PoE injector supplies up to 75W of power over a single Ethernet cable while passing network data to connected devices. Compact and designed for straightforward installation, this 75W power supply enables centralized delivery of power and data to compatible PoE-enabled equipment such as IP cameras and wireless access points, removing the need for separate power lines. The unit supports standard Ethernet connections and is intended for locations where adding dedicated power outlets is impractical.

Advantages

This PoE injector provides up to 75 watts over Ethernet, enabling support for higher-power devices without additional power cabling. Its compact form factor simplifies mounting in equipment rooms, cabinets or near network switches. The device delivers both power and data through one cable, reducing installation complexity and cable clutter. Built with basic surge and short-circuit protection, it helps maintain a stable power feed to connected devices when used according to specifications.

Suitable for

• Powering single high-power PoE devices such as PTZ IP cameras that require up to 75W
• Supplying access points, VoIP phones or network devices in locations without convenient power outlets
• Small installations and retrofits where running an extra power line is impractical

Key specifications

• Maximum PoE output: up to 75 W delivered over Ethernet
• Connectivity: single Ethernet data + power output and Ethernet data input
• Compatibility: designed for PoE-capable devices compliant with common PoE standards (check device requirements before use)
• Physical form factor: compact inline injector suitable for mounting near network equipment
• Protection features: built-in basic overcurrent and short-circuit protection

How to use

Install the PoE injector in a dry, ventilated location close to the network switch or router. Connect the network source to the injector’s data input port using a standard Ethernet cable, then connect the injector’s power+data output to the PoE device with a Category 5e or higher Ethernet cable. Ensure the connected device supports the injected power level and verify that the total power requirement does not exceed 75 W. Power the injector from an appropriate AC supply following local wiring regulations and confirm the device indicators indicate normal operation before leaving the installation unattended.

Lietošanas ieteikumi

Novietojiet ierīci vietā ar labu ventilāciju, aizsargājiet savienojumus no mitruma un regulāri pārbaudiet kabeļu stāvokli; pirms pievienošanas pārliecinieties, ka gala ierīce atbalsta piegādāmo jaudu un nerada pārslogojumu.