Patch cord ElectroBase K8100.05 0.5m CAT6 UTP

The ElectroBase K8100.05 0.5m CAT6 UTP patch cord is a short, high-performance network cable designed for reliable wired connections between networking devices. This CAT6 unshielded twisted pair cable supports high-speed data transmission and is suitable for compact installations where a short, durable link is required. Its 0.5 meter length makes it convenient for connecting switches, routers, patch panels and workstations in crowded racks or desktop setups without excess cable slack.

Advantages

The cable offers category 6 performance for improved bandwidth and reduced crosstalk compared with lower category cables, enabling reliable Gigabit Ethernet and multimedia streaming. Its unshielded twisted pair design simplifies installation in typical residential and office environments. The compact length reduces cable clutter and improves airflow in equipment racks while the robust connector terminations provide stable physical and electrical contact for consistent network performance.

Suitable for

• Short-distance connections between network equipment in home or office setups
• Patch panel to switch or switch to router links in data closets
• Desk-level connections for computers, VoIP phones and printers
• Temporary test and setup environments where a 0.5 m cable is convenient

Key specifications

• Cable category: CAT6
• Type: UTP (Unshielded Twisted Pair)
• Length: 0.5 m
• Conductor: copper (solid or stranded as per typical patch cord construction)
• Connector type: RJ45, 8P8C
• Supported applications: Gigabit Ethernet, Fast Ethernet, TCP/IP networks
• Operating environment: indoor use, standard ambient conditions

How to use

Connect one RJ45 connector to the network device (switch, router, patch panel or NIC) and the other end to the corresponding port on the connected device. Ensure connectors are fully inserted and the clip locks into place to maintain a reliable connection. Route the cable to avoid sharp bends and excessive tension; keep it away from high-voltage power lines to minimize potential interference. For rack or panel installations, use the 0.5 m length where short, direct connections are required.

Usage recommendations

For optimal performance, verify that connected equipment supports CAT6 or Gigabit speeds and that terminations on both ends are intact. Avoid kinking the cable, maintain bend radius recommendations (typically no less than four times the cable diameter), and replace the cable if connector damage or persistent link issues occur.