Switch disconnector Elektromet L-0-P 3P 25A IP44 in enclosure (model 952542)

Electromet L-0-P 3P 25A IP44 in enclosure (model 952542) is a three-pole switch disconnector designed to provide manual isolation of electrical circuits. The device is rated for 25 A and mounted in a protective enclosure with IP44 ingress protection, offering basic defence against solid objects larger than 1 mm and splashing water. Supplied ready in its enclosure, this switch disconnector is intended for installations where a clearly accessible manual isolator is required for maintenance, emergency shutdowns or circuit segregation.

Advantages

The switch disconnector offers straightforward manual operation and a compact, enclosure-mounted design that simplifies installation. With a three-pole configuration and a 25 A rating it enables safe disconnection of multi-phase circuits. The IP44 protection level reduces risk from accidental contact and environmental moisture, making the unit suitable for typical industrial and commercial locations where moderate protection is sufficient. Being supplied in an enclosure reduces the need for additional housing work on site.

Suitable for

• Manual isolation of three-phase circuits up to 25 A
• Maintenance and service disconnection in industrial and commercial sites
• Emergency shut-off points for machinery and local control panels
• Installation where basic protection against splashes and small foreign objects is required

Key specifications

• Poles: three-pole (3P)
• Rated current: 25 A
• Ingress protection: IP44 (protection against solid objects >1 mm and splashing water)
• Mounting: delivered pre-installed in an enclosure
• Operation: manual switch disconnector for circuit isolation

How to use

Mount the enclosure in a dry, accessible location following applicable electrical regulations and ensure correct tightening of incoming and outgoing conductors to the terminal connections. Use the manual actuator to open (disconnect) or close (connect) the circuit; verify the load is within the 25 A rating. Isolate power before performing any wiring or maintenance, and confirm the device is operated by a qualified person according to local safety standards.

Usage recommendations

For reliable operation, regularly inspect the enclosure seals and terminals for signs of corrosion or loosening. Avoid installing the unit in locations subject to direct high-pressure water jets or continuous exposure to heavy dust; for such environments choose equipment with a higher ingress protection rating. Follow local wiring rules and the manufacturer's installation instructions for torque values and conductor sizes.