PoE adapter EnGenius EPA5006GAT 1×GbE 54V 0.6A 30W 110–240V black

EnGenius EPA5006GAT is a compact single‑port PoE adapter that delivers both data and power over one Gigabit Ethernet (RJ‑45) cable. The adapter provides a 54 V / 0.6 A (30 W) output compatible with 802.3af/at powered devices and accepts 100–240 VAC input (47–63 Hz). With support for Ethernet data rates up to 1000 Mbps, an LED power indicator and a maximum cabling distance of 100 m, the unit is designed for office and SMB deployments where convenient, centralized powering of access points, IP cameras or VoIP phones is required. The small black housing (100 × 58.4 × 33.4 mm) simplifies installation in constrained spaces while maintaining standard Gigabit connectivity.

Advantages

The EnGenius EPA5006GAT combines power and Gigabit data on a single cable, reducing the need for local AC outlets at device locations and lowering installation time and cost. Compliance with 802.3af/at detection ensures compatibility with a wide range of powered devices, while built‑in protections for disconnect, short‑circuit and overload provide a secure and reliable connection. The adapter's compact form factor and clear power LED make it practical for deployments with limited port density or where discreet mounting is preferred.

Suitable for

• Powering 802.3af/at wireless access points in offices and small businesses
• Supplying Gigabit data and power to IP cameras and media devices
• Providing power to VoIP phones where AC outlets are not available
• Low port density or remote locations requiring a single cable solution

Key specifications

• Ethernet interface: 1 × Gigabit LAN (RJ‑45)
• PoE output: 54 V DC, 0.6 A, up to 30 W
• PoE standard compatibility: IEEE 802.3af / 802.3at
• Data rate: up to 1000 Mbps (Gigabit Ethernet)
• Input voltage: 100–240 VAC, 47–63 Hz
• Maximum cable distance: 100 m (over twisted‑pair Ethernet)
• Power indicator: LED
• Dimensions: 100 × 58.4 × 33.4 mm
• Colour: Black

How to use

Connect the adapter to a mains outlet using the integrated AC input, then plug the Gigabit Ethernet cable from the network switch or router into the data port and run the Ethernet cable from the adapter’s RJ‑45 output to the 802.3af/at powered device. Ensure cable runs do not exceed 100 m and that the connected device is compatible with 54 V PoE. The LED indicates mains and power status; observe device boot procedures as per the powered device's instructions.

Usage recommendations

For reliable operation, use Cat5e or higher quality Ethernet cable and maintain cable lengths within 100 m. Verify that the total power budget and device power class are supported by the 30 W output. Install the adapter in a ventilated, dry area away from direct heat sources and follow local electrical safety regulations during installation.