Fibre Optic Cable CUC Exertis Connect 392773

The CUC Exertis Connect 392773 is a 3 m OM3 fibre optic cable equipped with ST connectors on both ends and a 50 µm core diameter. Designed for multimode networks, this full-duplex fibre cable provides high-bandwidth signal transmission for campus, data centre and enterprise wiring where reliable optical links and low attenuation are required.

Advantages

This OM3 cable supports higher modal bandwidth compared with lower-grade multimode fibres, enabling greater data throughput over short to medium distances. The ST connectors offer a bayonet-style coupling for secure and repeatable connections in patch panels and networking equipment. Full-duplex capability allows simultaneous two-way communication, improving effective link performance in switched and routed environments.

Suitable for

• Data centre patching and horizontal cabling
• Campus network backbone links
• Server-to-switch fibre connections
• Network equipment testing and temporary installations

Key specifications

• Fibre type: OM3 multimode
• Length: 3 m
• Core diameter: 50 µm
• Connector type: ST–ST (both ends)
• Transmission mode: full duplex
• Cable jacket: multimode fibre jacket suitable for indoor networking

How to use

Inspect connector endfaces for cleanliness and, if necessary, clean with appropriate fibre-optic cleaning tools before installation. Route the 3 m cable between devices or into patch panels, avoiding tight bends and sharp kinks to maintain optical performance. Align the ST connector bayonet and push-turn until it locks; repeat for the opposite end. Verify link status and perform optical power or continuity tests as part of commissioning to confirm acceptable attenuation and connectivity.

Usage recommendations

Store and handle the cable to avoid excessive bending radii and mechanical stress. Use dust caps when connectors are not in use. For optimal performance in high-density or long-run installations, validate that OM3 multimode fibre meets your system’s bandwidth and distance requirements and consider fibre cleaning before each connection event.