This is due to long delivery times and limited product warranties.
Powerful EcoFlow stations for energy anywhere!
In cart {{totalProductsCount}} item(s)
Your cart is empty
Networking Cable Connect 850880 20m Cat6 F/UTP
The Exertis Connect 850880 20m Cat6 F/UTP is a 20-metre Ethernet patch cable designed for reliable wired network connections. The cable uses Cat6 wiring to support high-speed data transmission and incorporates F/UTP (foil-shielded with unshielded twisted pairs) construction to reduce electromagnetic interference. Both ends are terminated with standard RJ-45 connectors in a black jacket suitable for visible or concealed installations in home, office, or equipment-rack environments.
This Cat6 F/UTP cable delivers consistent Gigabit-capable performance over a 20 m length while the foil shielding helps protect signal integrity in environments with potential EMI. The RJ-45 terminations ensure compatibility with common switches, routers, network cards and patch panels. The black outer sheath provides a discreet appearance and basic mechanical protection suitable for routing along walls, under desks, or inside network enclosures.
Connect one RJ-45 end to your network device (router, switch or network port) and the other end to the target device (computer, printer or patch panel). Ensure connectors are fully inserted until they click to establish a secure connection. Route the cable to avoid tight bends and heavy compression; maintain gentle curves and secure with cable clips or Velcro ties where needed to prevent strain on connectors. For rack installations, use horizontal or vertical cable management to keep paths tidy and to avoid interference from power cabling.
For optimal performance, keep runs under recommended maximum distances for Cat6 standards and avoid running the cable in parallel with high-voltage power lines. Test connections after installation with a network cable tester to verify continuity and correct wiring. Use shielded patch panels or properly grounded equipment where shielding benefits are required.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}