PoE Injector and Splitter set Extralink 100Mb/s

The Extralink PoE Injector and Splitter set provides a reliable and efficient solution for powering network devices over a standard Ethernet cable. Designed to facilitate power delivery alongside data transmission, this set bridges the gap between non-PoE network hardware and required power sources. It enables seamless integration in various environments without the need to run separate electrical wiring to every endpoint.

Advantages

This Extralink PoE Injector and Splitter set allows network administrators and home users to supply power to devices over twisted pair cables even when the connected hardware does not support IEEE 802.3af or passive PoE standards. By combining power and data onto a single cable, it simplifies physical installations in hard-to-reach locations. The lightweight and compact construction ensures that the units take up minimal space and can be effortlessly deployed within existing network racks or tight enclosures. Additionally, the ability to use standard non-PoE network switches helps optimize overall deployment costs.

Suitable for

• Powering IP surveillance cameras lacking native Power over Ethernet support
• Connecting wireless LAN access points in locations without nearby power outlets
• Network setups utilizing non-PoE switches that require remote device powering
• Situations requiring simultaneous network data transmission at 100 Mb/s and power delivery over twisted pair cabling

When it may not be suitable

This device set may not be suitable for high-speed network infrastructures that require Gigabit Ethernet speeds, as the interface is limited to 10/100 Mbit/s. Furthermore, it is not designed for environments requiring complex power management or configurations where variable voltage outputs above or below 48 V are necessary.

Key specifications

• Data transfer rates: 10/100 Mbit/s Fast Ethernet
• PoE voltage: 48 V DC
• Ethernet LAN RJ-45 ports: 2
• Device weight: 44 g
• Components: Injector and splitter set

How to use

To use the Extralink PoE Injector and Splitter set, connect the injector unit to your network switch and power source to feed the voltage into the Ethernet cable. Run the twisted pair cable to the remote location where the target device is situated. At the receiving end, connect the Ethernet cable to the splitter unit, which then separates the data stream for the network port and delivers the appropriate voltage to the power jack connector of your non-PoE device. Ensure all cables are securely plugged in before turning on the power supply.

What to consider before purchase

• Verify that your remote device is compatible with a 48 V power supply input
• Check that your network performance requirements do not exceed the 100 Mb/s Fast Ethernet limitation
• Ensure you have adequate physical space for both the injector and splitter units in your setup

Usage recommendations: Always verify the power requirements of your connected hardware to match the 48 V specification before powering on the system. Use high-quality twisted pair Ethernet cables to maintain stable data transmission and power delivery over distance.