Fibre optic cable Extralink EX.15036, FTTH G.652D, LC–LC connectors, 5 m, yellow

Extralink EX.15036 is a 5 m FTTH single‑mode fibre optic patch cable featuring G.652D fibre and LC–LC connectors. With a 3.0 mm yellow jacket, the cable is intended for indoor fibre connections and FTTH installations, providing a low‑loss optical link between routers, ONTs, switches and fibre termination panels. The LC/UPC termini on both ends ensure reliable mating with standard LC interfaces and the yellow colour identifies it as a single‑mode line for easy routing in multi‑cable environments.

Advantages

The cable uses G.652D single‑mode fibre suitable for wavelengths from 1310 nm and systems up to 10 Gbps, offering low attenuation and stable performance. The LC–LC connector pair with UPC polishing provides precise ferrule alignment for minimal return loss. A 3.0 mm outer diameter and a 30 mm minimum bending radius balance flexibility and mechanical protection for indoor routing and patch panels. The 5 m length covers typical in‑room and rack interconnections without excess slack.

Suitable for

• FTTH connections between ONT/ONU and termination points
• Interconnects in patch panels and distribution frames
• Linking routers, switches and media converters in indoor networks
• 10 Gbps single‑mode systems and optical test setups

Key specifications

• Fibre type: Single‑mode G.652D
• Connector type: LC/UPC to LC/UPC (LC–LC)
• Length: 5 m
• Cable diameter: 3.0 mm
• Operational wavelength: from 1310 nm
• Minimum bending radius: 30 mm
• Jacket colour: Yellow (single‑mode identification)

How to use

Route the patch cable between the two devices or panel ports ensuring connectors remain clean before mating. Remove protective dust caps from both LC connectors, align and insert each LC connector into the corresponding LC adapter or port until it clicks. Avoid sharp bends and keep the bending radius above 30 mm during installation. For rack or panel installations, secure excess cable length with cable management accessories to prevent stress on connector ends.

Usage recommendations

Inspect and clean LC connector endfaces with appropriate fibre cleaning tools before each connection to maintain low loss and prevent damage. Store unused ends with dust caps fitted. Use this single‑mode patch cable for indoor FTTH and equipment interconnects; for outdoor or armoured runs, select a cable designed for external environments.