Flow water heater Fala Katla-1 3 kW, max pressure 0.6 MPa

Fala Katla-1 is a compact flow (instant) water heater with 3 kW rated electrical power and a maximum operating pressure of 0.6 MPa. The unit heats water on demand without a storage tank, delivering hot water directly at the point of use. Its small footprint and continuous flow operation make it suitable for single fixtures where occasional hot water is required. Installation requires a compatible electrical supply and standard cold and hot water connections.

Advantages

The flow design provides hot water immediately when a tap is opened, eliminating the need to wait for heated water from a distant central heater. Low rated power of 3 kW reduces the requirement for high-current electrical circuits compared with larger instant heaters, enabling installation in locations with limited electrical capacity. The compact housing and simple plumbing connections make it easy to mount near sinks or utility points, and the 0.6 MPa maximum operating pressure is suitable for many small domestic water systems.

Suitable for

• Bathroom sink or hand washbasin in small apartments
• Kitchen sink where intermittent hot water is needed
• Utility room, workshop sink, or laundry area with low-to-moderate water pressure

Key specifications

• Heating type: instantaneous (flow) water heater
• Rated electrical power: 3 kW
• Maximum operating pressure: 0.6 MPa
• Operation mode: continuous flow (on-demand)
• Intended installation: point-of-use, compact mounting
• Typical connections: cold water inlet and hot water outlet compatible with standard plumbing

How to use

Open the hot water tap to allow water to flow through the heater; the unit will activate and heat the water while it passes. Adjust the tap flow rate to change delivered water temperature within the limits of the heater's power and inlet temperature. Turn the tap off to stop water flow and heating. Ensure the electrical supply and plumbing are connected and switched on according to local regulations before use.

Usage recommendations

Install the unit close to the point of use to minimise heat loss and waiting time. Use on systems where inlet water temperature and desired hot water flow rate are within the practical limits for a 3 kW heater; lower inlet temperatures will reduce achievable outlet temperature. Verify that the local electrical circuit can safely supply a continuous 3 kW load and that water pressure does not exceed 0.6 MPa. Regularly inspect connections and follow local safety and installation codes.