Electric flow water heater Fala Strokkur-2 3.6 kW, max pressure 0.6 MPa (model 75931)

Fala Strokkur-2 is an electric flow (tankless) water heater with rated power 3.6 kW and maximum operating pressure 0.6 MPa. Designed for on-demand hot water supply, it heats water continuously as it flows through the unit without storing it. The compact housing and straightforward controls make this model suitable for point-of-use installations such as kitchen sinks, small bathrooms, or remote taps where immediate hot water is required and space is limited.

Advantages

The unit provides continuous heating only while water flows, eliminating standby heat loss associated with storage heaters. Its 3.6 kW rated power enables quick temperature rise at low to moderate flow rates, and the maximum operating pressure of 0.6 MPa allows connection to typical domestic water lines. The compact design simplifies installation close to the tap, reducing heat losses in supply lines. The simple electrical and hydraulic configuration makes maintenance and servicing straightforward.

Suitable for

• Point-of-use hot water at single sinks
• Small bathrooms or shower units with low flow requirements
• Remote taps in outbuildings, garages or utility rooms
• Applications where space-saving instant heating is needed

Key specifications

• Type: Electric flow (tankless) water heater
• Rated power: 3.6 kW
• Maximum operating pressure: 0.6 MPa
• Operation: On-demand continuous water heating while flowing
• Installation: Point-of-use mounting near the outlet

How to use

Install the heater in accordance with local electrical and plumbing regulations, positioning it close to the intended outlet to minimise pipe length. Connect the cold water supply and hot water outlet according to the installation instructions and ensure reliable grounding and protective devices on the electrical supply. When the tap is opened, water flows through the unit and the heating element raises the water temperature; adjust the flow rate to achieve the desired outlet temperature within the device’s heating capacity. Turn off electrical power before performing any maintenance or inspection.

Usage recommendations

Use the heater where flow rates remain within the device’s capability to ensure adequate temperature rise. For installations with hard water, consider water treatment or periodic descaling to maintain efficiency. Verify that the building electrical circuit and protective devices match the heater’s power requirements and follow recommended safety and grounding practices.