Screw Anchor Fischer 564579 50 pcs 95 mm for Brick Concrete

The Fischer bolt anchor FAZ II Plus is a steel expansion anchor designed for high-load applications in cracked and non-cracked concrete as well as other approved substrates. The anchor is suitable for securing railings, cable trays, consoles and similar fixtures. The Fischer 564579 screw anchor version is made from zinc-plated steel, has an M10 connecting thread, a diameter of 10 mm and a length of 95 mm; the pack contains 50 pieces.

Advantages

The FAZ II Plus enables faster and easier installation by eliminating the need for drill hole cleaning for sizes M8–M24. Multiple approval certificates cover a wide range of substrate materials (concrete C12/15–C80/90, steel fibre concrete, solid sand-lime brick), increasing possible applications. New ETA assessment increases tensile strengths so fewer fixing points may be required. Fire-resistant test reports (ETA, RWS, ZTV, ETK) confirm high load capacity under fire conditions. Independent assessment indicates a service life of up to 120 years for M10–M16 sizes. The anchor can absorb high seismic loads (performance categories C1 and C2) for diameters M10–M24, with or without the filling disc FFD, and variable anchorage depths allow millimetre-accurate adjustment to loads.

Suitable for

• Anchoring railings and balustrades
• Fixing cable trays and electrical conduits
• Mounting consoles and support brackets
• Heavy-duty fixings in cracked concrete

Key specifications

• Brand: FISCHER
• Model: FAZ II Plus (screw anchor Fischer 564579)
• MPN: 564579
• EAN: 4048962462043
• Material: zinc-plated steel
• Thread: M10
• Diameter: 10 mm
• Length: 95 mm
• Pack quantity: 50 pieces
• Approved substrates: concrete C12/15–C80/90, steel fibre concrete, solid sand-lime brick
• Seismic performance categories: C1, C2 (M10–M24)

How to use

Drill the required hole to the approved diameter and depth. For sizes M8–M24, hole cleaning is not required. Insert the FAZ II Plus anchor either as a pre-positioned or push-through installation; the long thread also allows stand-off mounting. Tighten the bolt applying the specified installation torque; the cone is pulled into the expansion sleeve and presses it against the drill-hole wall. The anchor is set when the preset torque is reached. For series installations use the FABS or FA‑ST II anchor bolt setting tools. If seismic requirements apply, consider using the filling disc FFD to fill the annular gap.

Использование — рекомендации

Используйте анкера в соответствии с приложенной документацией и одобрениями (ETA и другие отчёты), соблюдайте рекомендованный момент затяжки и монтажные глубины. Для серийного монтажа применяйте специализированные инструменты FABS или FA‑ST II. При необходимости повышенной сейсмостойкости используйте заполняющий диск FFD. Не придумывайте или изменяйте характеристики анкера: соблюдайте требования производителя и нормативов.