Screw Anchor Fischer 564582 20 pcs 135 mm Zinc Plated Steel M10

The Fischer screw anchor FAZ II Plus (MPN 564582) is a zinc-plated steel expansion anchor with M10 thread, 135 mm length and a drill hole diameter of 10 mm. Supplied in a pack of 20 pieces, this anchor is designed for use in concrete, solid sand-lime brick and other approved substrates. It offers high tensile strengths, long service life and suitability for demanding construction applications including use in cracked concrete and seismic zones.

Advantages

The FAZ II Plus enables faster and easier installation by eliminating the need for drill hole cleaning for sizes M8–M24. Multiple approval certificates for substrates such as concrete (C12/15–C80/90), steel fibre concrete and solid sand-lime brick expand its application range. New ETA assessment increases tensile strength, which can reduce the number of fixing points required. Fire test reports (RWS, ZTV, ETK) and the ETA support high load capacity under fire conditions. An independent assessment confirms an expected service life of up to 120 years for appropriate uses (noted for sizes M10–M16). The anchor also accepts high seismic loads (performance categories C1 and C2) for diameters M10–M24, with or without the filling disc FFD, and offers variable anchorage depths for millimetre-accurate adjustment to loads.

Suitable for

• Anchoring railings and handrails
• Fixing cable trays and supports
• Mounting consoles and brackets
• Heavy-duty fixings in cracked concrete and approved masonry

Key specifications

• Brand: FISCHER
• Model / MPN: 564582
• Type: Screw anchor FAZ II Plus (steel expansion anchor)
• Thread size: M10
• Length: 135 mm
• Drill hole diameter: 10 mm
• Material / finish: Zinc plated steel
• Pack contents: 20 pieces
• Approved substrates: Concrete C12/15–C80/90, steel fibre concrete, solid sand-lime brick (per approvals)
• Seismic performance: Suitable for C1 and C2 (M10–M24)
• Service life (assessment): Up to 120 years (per independent evaluation, relevant for some sizes)

How to use

Drill a hole of the specified diameter (10 mm) and depth for the chosen anchorage length. For sizes M8–M24, hole cleaning is not required for this anchor. Insert the FAZ II Plus anchor in pre-positioned or push-through installation and, if needed, use stand-off installation thanks to the long thread. Apply the prescribed installation torque; the cone bolt will be pulled into the expansion sleeve and expand it against the drill hole wall. The anchor is set when the preset torque is achieved. For series installation use recommended setting tools such as FABS or FA-ST II. If seismic demands apply, consider using the filling disc FFD to fill the annular gap.

Usage recommendations

The anchor must be installed in accordance with the applicable approvals and technical documentation. Respect substrate-specific requirements, the prescribed installation torque and embedment depths. Use the designated setting tools for efficient series installation and the filling disc FFD when required for seismic or gap-filling applications.