Replacement UV Sterilization Lamp Garni technology GARNI UV 45T 45W

Replacement UV Sterilization Lamp Garni technology GARNI UV 45T 45W is a compatible replacement lamp designed to restore ultraviolet output in devices that use 45 W T-type UV tubes. It delivers UV-C radiation suitable for disinfection tasks specified by the device manufacturer and is intended for use in water and air sterilizers and other compatible systems. The lamp is supplied as a single replacement component to maintain UV intensity and prolong effective microbial control when original lamp output has declined.

Advantages

The lamp provides a consistent 45 W power level and matches the form factor of standard T-type UV replacement lamps, making installation straightforward in compatible units. Using a replacement UV lamp helps maintain the sterilizer’s designed disinfection performance by restoring ultraviolet intensity, which can decrease over time with continuous operation. The construction follows typical specifications for UV-C tubes intended for sterilization, enabling predictable output and stable operation when installed and used according to manufacturer guidance.

Suitable for

• Replacement in compatible Garni technology and similarly specified UV sterilizers
• Water sterilization units that accept 45 W T-type UV lamps
• Air sterilizers or purifiers designed for external UV-C lamp replacement
• Maintenance of laboratory or aquaculture UV disinfection systems requiring 45 W tubes

Key specifications

• Rated power: 45 W
• Type: T-type UV-C replacement lamp
• Radiation: UV-C output for disinfection applications
• Intended use: water and air sterilization devices and compatible systems
• Form factor: straight tubular design for direct replacement in compatible fixtures

How to use

Before installation, ensure the sterilizer is powered off and disconnected from mains supply. Wear appropriate protection such as gloves and avoid direct eye and skin exposure to UV-C light. Remove the expired lamp according to the sterilizer manufacturer’s instructions and install the replacement lamp, ensuring secure seating in the lamp holders and correct electrical connections. After installation, restore power and allow the device to run through any required warm-up period for stable UV output. Follow any device-specific calibration or runtime checks recommended by the sterilizer manufacturer.

Usage recommendations

Replace the lamp at intervals recommended by the sterilizer manufacturer or when measured UV output drops below effective levels. Do not operate the sterilizer with covers removed or without any protective shielding in place. Dispose of the used lamp according to local regulations for lamps containing low levels of mercury and recycle where facilities exist.