GF elbow 90° press-fit clamp 20 mm, brass — GF 5S0020H202000T

GF elbow 90° press-fit clamp 20 mm, brass — GF 5S0020H202000T is a right-angle plumbing fitting designed for press-fit installation with an integrated clamp. Made from brass, this 90° elbow connects two pipes with a nominal diameter of 20 mm to form a sealed change of direction in potable water, heating and service distribution systems. The design supports durable, low-maintenance joints where a press connection combined with a clamping element is required.

Advantages

The brass construction provides corrosion resistance and mechanical strength suitable for domestic and commercial installations. The press-fit connection ensures consistent, gas- and water-tight joints without the need for flame or soldering, reducing installation time and safety risks. The clamp feature improves axial stability and helps maintain seal integrity under variable pressure or temperature conditions.

Suitable for

• Potable water supply systems
• Domestic and commercial heating circuits
• Service lines for sanitary fixtures and appliances
• Retrofit and new-build plumbing projects where secure right-angle connections are needed

Key specifications

• Type: 90° elbow with press-fit connection and clamp
• Material: brass
• Nominal pipe diameter: 20 mm
• Connection method: press-fit with clamping element
• Application: potable water, heating and service pipelines

How to use

Prepare the pipe ends by cutting square and deburring the inner and outer edges. Mark insertion depth on the pipe to ensure correct seating. Position the elbow onto the prepared pipe end and use a compatible press-tools and jaws specified for 20 mm press fittings to compress the fitting until the press profile is fully formed. Verify the clamp aligns correctly and that the pressed joint meets the manufacturer’s visual or gauge indicators. After pressing, perform pressure and leak tests according to local regulations and system requirements.

Usage recommendations

Use only approved press tools and jaws rated for 20 mm brass press fittings, and follow installation and testing standards for potable water and heating systems. Avoid mechanical stresses on the joint during system backfilling or commissioning, and inspect pressed connections visually and with appropriate gauges when required.