Networking Cable Alcasa 8060-SF100 Grey 10m Cat6a S/FTP

The Alcasa 8060-SF100 Grey 10m Cat6a S/FTP networking cable provides a reliable wired connection for data networks where high throughput and reduced interference are required. Constructed to Cat6a standard with S/FTP shielding, this 10 m cable pairs foil-wrapped pairs with an overall braided screen to minimize crosstalk and external electromagnetic interference. Both ends are fitted with RJ-45 plugs featuring gold-plated contacts to support stable signal transfer and corrosion resistance. The neutral grey jacket is suited for visible installations in homes, offices, or rack environments.

Advantages

Cat6a specification support enables 10 Gigabit Ethernet speeds over copper in appropriate network setups while the S/FTP shielding provides additional protection against near-end crosstalk and external noise sources. Gold-plated RJ-45 connectors ensure consistent contact and lower contact resistance, improving long-term connection stability. The 10 m length offers flexibility for connecting devices across rooms or between equipment racks without the need for couplers or patch panels in many typical layouts.

Suitable for

• Connecting switches, routers and networked computers in small offices
• Home networking for streaming, gaming consoles and media devices
• Patching between wall outlets and desktop or rack equipment
• Environments with moderate electromagnetic interference where shielded cable is beneficial

Key specifications

• Category: Cat6a
• Shielding: S/FTP (overall braid with individually foiled pairs)
• Length: 10 m
• Connectors: RJ-45 to RJ-45
• Contact plating: gold-plated contacts
• Colour: Grey

How to use

Route the Alcasa Cat6a cable between the two devices to be connected, avoiding sharp bends and excessive tension that could damage the internal pairs or shielding. Insert each RJ-45 plug fully into the corresponding network port until it clicks. For in-wall or permanent installations verify local building and cabling codes before embedding the cable; use additional grounding where required for shielded cabling. Test the connection after installation with a network tester or by verifying link activity and throughput on connected devices.

Usage recommendations

For optimal performance, keep the cable away from sources of strong electromagnetic interference (motors, fluorescent ballasts, large power cables). When integrating into shielded systems, ensure proper termination of the cable shield to ground at one end or as specified by your network grounding scheme. Use the 10 m length for direct device-to-device connections or short patch runs; for permanent or concealed runs follow local regulations and use appropriate mounting and strain-relief methods.