Coaxial Cable Kabelmeister FD-S20FF 0.227m SMA Black

The Kabelmeister FD-S20FF 0.227m SMA Black is a coaxial cable designed for short-distance RF signal connections. With SMA male connectors on both ends and a 0.227 meter length, this cable is intended to provide reliable, low-loss transmission between devices that use standard SMA interfaces. Its black jacket offers basic mechanical protection and a discreet appearance suitable for installations where cable visibility is a consideration.

Advantages

This coaxial cable offers consistent impedance matching and a compact form factor for confined spaces. The SMA-to-SMA termination reduces the need for adapters when connecting compatible radio, antenna, or measurement equipment. Its short length minimizes signal attenuation and potential interference while maintaining mechanical flexibility for easy routing behind equipment racks or inside enclosures.

Suitable for

• Connecting RF modules and transceivers with SMA interfaces
• Linking antennas to routers, modems, or radios over short distances
• Laboratory and test-bench setups for signal measurements
• Internal cabling within equipment racks and enclosures

Key specifications

• Cable type: coaxial
• Connector type: SMA on both ends (male-to-male configuration)
• Length: 0.227 m
• Jacket color: black
• Typical use: RF signal transmission for short runs

How to use

Ensure each SMA connector is aligned with the mating connector before threading to avoid cross-threading. Tighten connectors finger-tight first and then apply a small additional torque using an appropriate wrench if specified by the connected equipment’s guidelines; avoid over-tightening. Route the cable with gentle bends greater than the cable’s minimum bend radius to prevent internal damage. For measurement tasks, connect the cable between the device under test and the measurement instrument, verifying connector integrity and signal continuity before applying power or transmitting signals.

Usage recommendations

Store the cable coiled loosely to prevent kinks, and avoid exposure to excessive mechanical stress or sharp edges. For critical or high-frequency applications, inspect connectors for contamination and ensure proper mating torque to maintain signal integrity.