Network Cable Hewlett Packard Enterprise PROCURVE 10-GBE SFP 7M Direct RP000345015 HP Enterprise

The Hewlett Packard Enterprise PROCURVE 10-GBE SFP 7M Direct cable is a pre-terminated, 7-meter twinax assembly designed for short-reach 10 Gigabit Ethernet connections between SFP+ ports. Engineered for use with compatible HP Enterprise switches and networking equipment, this direct attach cable provides a single-cable solution for high-throughput, low-latency links in rack, cabinet and data center topologies. The cable construction and shielding reduce signal loss and maintain consistent 10 Gbps performance over the specified distance.

Advantages

This 10-GBE SFP direct cable offers a compact and low-power alternative to optical transceivers and fiber cabling without sacrificing throughput. Its fixed 7 m length simplifies cable management and preserves port density in switch racks. Built for interoperability with HP Enterprise hardware, the cable delivers stable connections with minimal configuration required and a durable build intended for repeated installations and rack movement.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and servers in racks
• High-throughput links in small and medium data centers
• Direct connections for aggregation or top-of-rack switch deployments
• Environments where cost-effective, low-latency copper links are preferred to optics

Key specifications

• Data rate: 10 Gbps (10 Gigabit Ethernet)
• Connector type: SFP+ direct attach (fixed twinax cable with SFP+ ends)
• Length: 7 meters
• Cable medium: Shielded direct-attach copper (twinax)
• Typical latency: low, suitable for latency-sensitive applications
• Operating environment: designed for indoor use in racks and cabling channels

How to use

Install the cable by plugging each SFP+ end into the corresponding SFP+ ports on compatible HP Enterprise switches or servers. Ensure both ports are powered and configured for 10 Gigabit operation; auto-negotiation or manual configuration on the switch may be required depending on the network setup. Route the cable to avoid sharp bends and mechanical stress; secure it with cable ties or management panels to prevent strain on connectors. After installation, verify link status and speed through switch management interfaces.

Usage recommendations

Use this direct attach cable for short-reach, high-bandwidth connections where 7 m length is appropriate. Avoid running the cable in outdoor or unshielded environments, and maintain bend radii recommended for twinax cables to preserve signal integrity. For deployments requiring longer distances or optical isolation, consider fiber-based SFP+ solutions instead.