PoE Midspan Injector HP Aruba AP-POE-ATSR 1-Port Smart Rate 802.3at 30W (R6P67A)

HP Aruba AP-POE-ATSR is a single-port PoE midspan injector designed to provide power and data to one IEEE 802.3at-compatible device. With Smart Rate support and a total PoE budget of 30 W, this compact injector supplies both network connectivity and up to 30 watts of DC power over a single Ethernet cable. Its small footprint (30 × 66 × 163 mm) allows installation in constrained spaces or near access points where an inline power source is required.

Advantages

This one-port midspan injector supports IEEE 802.3at Power over Ethernet, delivering up to 30 W to a connected device while preserving Smart Rate network performance. The compact size simplifies placement close to access points or network edge devices, reducing cable runs and avoiding the need to replace existing non-PoE switches. It provides a straightforward power-and-data solution for deployments that require a reliable single-port PoE source.

Suitable for

• Powering a single wireless access point that requires 802.3at PoE
• Supplying PoE to an IP camera or VoIP phone where a PoE switch is not available
• Edge installations and retrofits where only one device needs inline power
• Closely mounted deployments with limited space for additional networking hardware

Key specifications

• PoE standard: IEEE 802.3at (PoE+), Smart Rate supported
• Total PoE power budget: 30 W delivered to the connected device
• Ports: single Ethernet data+power port and one data input port
• Physical dimensions: 30 × 66 × 163 mm for compact installation
• Application: midspan injector for inline power over Cat5e/Cat6 cabling

How to use

Install the injector between an existing network switch and the powered device by connecting the network switch to the injector’s data input port and the access point or other PoE device to the data+power output port. Ensure the connected device supports IEEE 802.3at and that cabling meets Cat5e or better standards. Provide AC power to the injector per the included power adapter instructions and verify the device receives power and network connectivity after connections are made.

Usage recommendations

Place the injector close to the powered device to minimize cable length and signal loss. Verify power requirements of the target device to ensure the 30 W budget is sufficient. Use quality Ethernet cables and follow standard installation practices for grounding and environmental placement to maintain reliable operation.