Angle Adapter for Faucet Hydroland A.PRZYŁ.KĽT.C-D — chrome, connection D 1/2 x 3/4, 1 piece

Angle adapter for Faucet Hydroland A.PRZYŁ.KĽT.C-D in chrome finish is a single-piece plumbing connector designed to change the flow direction and adapt between different thread sizes. The adapter provides a right-angle connection and transitions between 1/2" and 3/4" D-type threaded fittings, allowing installation where existing pipes or fixtures use incompatible thread sizes or require a compact angular joint. Its chrome surface offers corrosion resistance and a finish that matches common faucet and trim styles.

Advantages

The adapter is a single-piece construction that simplifies installation and reduces the number of connections where leaks could occur. Chrome plating improves durability and resists tarnishing in typical domestic environments. The 90-degree orientation enables space-saving installation in tight areas behind sinks or inside cupboards, and the size transition from 1/2" to 3/4" removes the need for additional reducers or complex rework of existing plumbing.

Suitable for

• Bathroom faucet installations requiring a right-angle connection
• Kitchen sink plumbing with limited space behind fixtures
• Adapting between 1/2" and 3/4" D-type threaded fittings
• Replacement or repair where a compact angled joint is needed

Key specifications

• Finish: chrome
• Connection type: D-type threaded connector
• Thread sizes: 1/2" x 3/4"
• Orientation: 90-degree (angle adapter)
• Quantity: 1 piece

How to use

Shut off water supply before installation. Remove any existing fittings and clean thread surfaces. Apply appropriate thread sealant or plumber's tape on threaded ends if required by local plumbing practice. Screw the adapter into the corresponding female or male D-type thread by hand, then tighten with a wrench until secure but avoid over-tightening to prevent damage to threads or chrome plating. Restore water supply and check for leaks at the joints, retightening slightly if necessary.

Usage recommendations

Use thread sealant compatible with potable water systems and avoid aggressive sealants that may harm chrome finishes. Inspect threads for damage prior to installation and ensure mating fittings are of D-type thread form. For concealed or hard-to-reach installations, verify alignment before final tightening to prevent strain on connected pipes or fixtures.