INCA Patch Cable RJ45 Cat6 UTP 250 MHz — 3.00 m — blue

INCA Patch Cable RJ45 Cat6 UTP 250 MHz — 3.00 m — blue is a Cat6 unshielded twisted pair (UTP) patch cable designed for Fast Ethernet and Gigabit networks. The 3.00 m length and RJ-45 male connectors at both ends make it suitable for connecting switches, routers, patch panels and network devices in home or office LANs. Cat6 performance up to 250 MHz reduces crosstalk and supports reliable data transmission over typical short link runs. The cable uses solid 0.57 mm conductors with polyolefin insulation and a coloured jacket for easier identification.

Advantages

The INCA Cat6 UTP cable provides category-appropriate performance for 10/100/1000 Mbps networks while keeping a straightforward, unshielded construction. Solid conductors and consistent pair colour coding support predictable electrical characteristics and easier termination. A 3 m length offers flexibility for patching between equipment in racks or desktop setups, and the visible jacket colour helps with cable management and quick recognition.

Suitable for

• Connecting switches, routers and patch panels in small office or home networks
• Gigabit Ethernet links (1000BASE-T) over short runs
• Patching between wall outlets and network devices
• Temporary or permanent desk and rack cable runs up to 3 m

When it may not be suitable

This UTP cable has no additional shield, so it may not be ideal for environments with high electromagnetic interference where STP/FTP cable would perform better. The 3.00 m length is intended for short connections; it is not suitable where longer cable runs or in-wall permanent installation over distances exceeding the recommended limits are required.

Key specifications

• Cable length: 3.00 m
• Category: Cat6 U/UTP (unshielded twisted pair)
• Rated frequency: up to 250 MHz
• Conductor type: solid copper, 0.57 mm
• Number of conductors: 8 (4 twisted pairs)
• Insulation material: polyolefin
• Pair colour code: Blue/White-Blue, Orange/White-Orange, Green/White-Green, Brown/White-Brown
• Connector type: RJ-45 male to RJ-45 male
• Supported standards: 10BASE-T, 100BASE-TX, 1000BASE-T
• Jacket colour: yellow
• Operating temperature: -20°C to +50°C; storage: -20°C to +70°C
• Bending radius: recommended 8× outer diameter (handling) / 4× outer diameter (fixed)

How to use

Plug each RJ-45 connector into the corresponding network ports of devices you wish to connect, ensuring secure seating until the connector latch clicks. Use the 3.00 m INCA Cat6 UTP cable to create short patch connections between wall ports, switches and network equipment. Avoid tight bends and kinks; follow the recommended bending radius to preserve signal integrity. For installations in patch panels or keystone jacks, verify pinout compatibility and test continuity and performance using a cable tester after installation.

What to consider before purchase

• Required cable length—3.00 m is suitable for short runs
• UTP (unshielded) construction versus shielded alternatives if EMI is a concern
• Compatibility with Gigabit Ethernet if you need 1000BASE-T performance
• Jacket colour for your cable management and labelling preferences

Usage recommendations

For best performance, route the cable away from large electrical equipment and maintain gentle curves with a minimum bending radius as specified. Test connections after installation to confirm link speed and signal integrity.