INTELLINET Media Converter 1000Base-T RJ45 to 1000Base-LX SM SC 10 km 1310 nm

INTELLINET Media Converter 1000Base-T RJ45 to 1000Base-LX SM SC 10 km 1310 nm converts Gigabit Ethernet over copper to single-mode fiber, enabling seamless extension of network links up to 10 km. The device provides a 1000Base-T RJ45 port for connection to switch or router copper ports and a 1000Base-LX SC fiber port operating at 1310 nm for single-mode fiber runs. It is intended for environments where reliable Gigabit connectivity is required between buildings, across a campus, or within telecom access networks.

Advantages

This media converter supports transparent layer-1 conversion between copper and single-mode fiber without altering Ethernet frames, preserving network protocols and reducing the need for additional configuration. Its support for Gigabit speeds ensures full duplex 1000 Mbps throughput over both copper and fiber links. The SC connector and 1310 nm wavelength provide compatibility with standard single-mode fiber installations and long-reach connections up to 10 km, minimizing the need for repeaters or intermediate devices.

Suitable for

• Extending office or campus Ethernet links between buildings over single-mode fiber
• Connecting network switches or routers to remote fiber infrastructure
• Integrating copper-based equipment into telecom or ISP fiber backbones
• Point-to-point Gigabit links for surveillance, access control, or server connectivity

Key specifications

• Data rate: Gigabit Ethernet (1000 Mbps)
• Copper interface: 1000Base-T via RJ45
• Fiber interface: 1000Base-LX via SC connector
• Fiber type: single-mode (SM)
• Operating wavelength: 1310 nm
• Maximum reach: up to 10 km over single-mode fiber
• Duplex mode: full duplex support

How to use

Connect the RJ45 port to a switch, router or network device using standard Cat5e/Cat6 cabling and connect the SC fiber port to a single-mode fiber cable terminated with SC connectors. Ensure correct fiber polarity and verify that the remote fiber endpoint supports 1000Base-LX at 1310 nm. Power the converter according to the supplied power adapter or chassis installation method and confirm link LEDs to verify synchronization and network activity. No additional software configuration is typically required for basic layer-1 conversion.

Usage recommendations

Install the converter in a clean, ventilated environment and route fiber and copper cables to avoid sharp bends and physical stress. Use single-mode fiber with appropriate attenuation characteristics for runs approaching the 10 km limit, and verify connectors and splices for low insertion loss. For deployments requiring redundant links or managed monitoring, consider using this media converter in conjunction with managed switches or monitoring systems.