T-fitting INVENA PE/PE 32 (model PE-62-032) for polyethylene pipes, 32 mm

INVENA T-fitting PE/PE 32 (model PE-62-032) is a polyethylene three-way connector designed for use with 32 mm PE pipes. It creates a stable mechanical junction between three polyethylene lines and is intended for installation in potable water, irrigation and general fluid distribution systems where compatible PE piping is used. The fitting is suitable for creating a branch in existing pipelines and for assembling new PE distribution networks that require a reliable, corrosion-resistant joint.

Advantages

The fitting offers a compact design that integrates with standard 32 mm polyethylene pipes and provides corrosion resistance inherent to PE materials. Its construction ensures a leak-resistant mechanical connection when properly installed, and the part is suitable for use in systems transporting potable water as well as irrigation and general fluid applications. The simple geometry of the T-fitting reduces flow disturbances and facilitates routing of three lines from a single junction point.

Suitable for

• Connecting three 32 mm polyethylene pipes in potable water distribution
• Creating branches in irrigation networks for gardens, allotments, and agriculture
• General fluid distribution in residential and light commercial plumbing systems

Key specifications

• Material: polyethylene (PE)
• Connection type: PE/PE mechanical junction for 32 mm pipes
• Nominal pipe diameter: 32 mm
• Configuration: T-shaped, three-way branch
• Typical applications: potable water, irrigation, general fluid transport

How to use

Prepare the 32 mm PE pipes by cutting squarely and ensuring ends are clean and free of debris. Insert each pipe end into the corresponding socket of the T-fitting following the manufacturer’s recommended insertion depth and alignment. Use the appropriate joining method specified for the fitting and piping system—this may include mechanical compression, electrofusion or other PE-compatible joining techniques—ensuring joints are secured and leak-tested according to installation standards. After assembly, perform a pressure or leak test to confirm integrity before placing the system into service.

Usage recommendations

Use the INVENA T-fitting with PE pipes of matching 32 mm diameter and follow local plumbing codes and manufacturer instructions for joining and testing. Avoid exposing the assembled joint to prolonged mechanical stress or sharp bending. For potable water systems, ensure materials and installation practices comply with applicable drinking water regulations.