Mounting kit JUNG 893-2, white thermoplastic, accessory for electrical switches and sockets

JUNG 893-2 mounting kit is a white thermoplastic accessory designed for use with electrical switches, sockets and WD-series housings. The kit includes a mounting insert with a metric M20x1.5 thread that provides a reliable, non-conductive threaded connection point for cable glands, conduit fittings and compatible accessories. It is intended for indoor residential and commercial installations where a standardized threaded interface and stable mechanical fixation are required.

Advantages

The M20x1.5 threaded insert offers industry-standard compatibility with a wide range of cable glands and fittings, simplifying component selection and installation. Made from durable thermoplastic, the insert is non-conductive and resistant to typical indoor environmental influences, supporting safe electrical installations. Its precise thread form and design maintain alignment of mounted components and allow secure mechanical fixation without additional adapters.

Suitable for

• Mounting cable glands and conduit fittings with M20x1.5 thread
• Securing sensors, switches or control components in WD housings
• Electrical and instrumentation panels requiring a threaded interface
• Retrofits and maintenance tasks where original threaded points are needed

Key specifications

• Thread type: metric M20x1.5
• Material: white thermoplastic
• Application: mounting insert for WD-series housings and compatible enclosures
• Function: provides a threaded connection point for mechanical fixation and accessory installation
• Intended use: indoor electrical installations in residential or commercial settings

How to use

Select a compatible WD housing or enclosure with a receiving hole sized for an M20x1.5 insert. Ensure the housing hole and the accessory to be mounted both match the M20x1.5 thread. Insert the mounting piece into the prepared opening following the housing manufacturer’s orientation guidance, then engage the accessory or gland by screwing it onto the M20x1.5 thread until it is mechanically secure. After installation, verify the mechanical stability and, if applicable, sealing and electrical continuity according to installation requirements.

Usage recommendations

Apply appropriate torque when tightening threaded fittings to prevent damage to the thermoplastic thread and to ensure correct sealing with cable glands. Inspect the insert and mating threads for wear or deformation during maintenance and replace the insert if damaged. Observe relevant electrical safety rules and local standards when integrating the insert into final assemblies.