Power regulator Kontakt-Simon DS9V.01/11 1–10V lighting dimmer white

Kontakt-Simon DS9V.01/11 is a white 1–10V power regulator designed to switch and dim compatible lighting fixtures. The unit provides an analog 1–10V control interface for smooth, continuous adjustment of luminaires that accept low-voltage control. Its compact design fits standard flush wall mounting boxes and is intended for use in residential and commercial electrical installations for single luminaires or groups of fittings.

Advantages

The regulator provides stable analog 1–10V dimming and on/off switching, enabling gradual brightness changes without abrupt steps. The white finish is neutral and unobtrusive, and the module is designed for straightforward installation into standard mounting boxes. It supports continuous stepless adjustment and is suitable for lighting loads that follow the 1–10V control protocol.

Suitable for

• Controlling LED drivers and luminaires with 1–10V control input
• Residential rooms requiring local dimming (living rooms, bedrooms)
• Commercial spaces such as offices, meeting rooms and hospitality areas needing adjustable ambient light
• Integration into small centralized lighting control systems or standalone local control circuits

When it may not be suitable

This regulator is not suitable for lamps or drivers that do not support a 1–10V control interface; it will not provide dimming for fixtures that require other protocols (for example DALI, DMX or devices that only accept mains trailing/leading-edge dimming without a 1–10V input). The device is intended for installations where compatible low-voltage control wiring is available and may require a qualified electrician for correct integration in multi-circuit setups.

Key specifications

• Control type: analog 1–10V dimming and on/off switching
• Color/finish: white
• Mounting: flush wall mounting into standard electrical boxes
• Load compatibility: fixtures and drivers with 1–10V control input
• Adjustment: continuous, stepless brightness control

How to use

Install the dimmer into a standard flush mounting box and connect the control wires to the 1–10V input of the compatible LED driver or luminaire following the wiring diagram provided by the lighting manufacturer. Use the control element to switch the lighting on or off and to adjust brightness gradually. When integrating with a central control system, observe correct polarity and shielding of control cables and follow local electrical codes; commissioning should include testing each channel and confirming smooth dimming across the intended load range.

What to consider before purchase

• Confirm that target luminaires or LED drivers support 1–10V control input
• Verify compatibility with the installation's mounting boxes and faceplate system
• Check required wiring and whether additional control modules or a central controller are needed
• Ensure electrical ratings and load limits match the combined connected fixtures

Usage recommendations

Pair the dimmer with drivers specifically rated for 1–10V control, use short and properly routed control wiring, and complete commissioning with the full set of connected luminaires to confirm uniform dimming behavior across the installation.