Patch Cord LANBERG PCF6-20CC-0200-B Cat6 U/UTP RJ45 2 m Blue, CCA, 250 MHz, 10 Gbps

LANBERG PCF6-20CC-0200-B is a Cat6 U/UTP patch cord with RJ45 male connectors at both ends and a 2 m blue PVC jacket. The cable uses 26 AWG copper-clad aluminium (CCA) conductors with an outer diameter of 5.4 mm, supports frequencies up to 250 MHz and data rates to 10,000 Mbps, and is intended for Ethernet connections between network devices, patch panels and wall outlets in office or home LAN installations.

Advantages

This patch cord provides the electrical characteristics of the Cat6 standard for structured cabling while offering a cost-effective conductor option with copper-clad aluminium. The U/UTP construction (unshielded twisted pairs within an overall PVC jacket) keeps the cable flexible and easy to route in patching environments. Standard RJ45 male connectors on both ends ensure compatibility with switches, routers, patch panels and network interface ports. The 2 m length and blue colour make it suitable for visible patching runs and simple identification in patch racks.

Suitable for

• Connecting computers, switches, routers and NAS in office or home networks
• Patch panels and horizontal patching between network racks
• Short to medium-length Ethernet links where Cat6 performance is required up to 250 MHz

Key specifications

• Cable category: Cat6 (U/UTP)
• Length: 2 m
• Conductor type and size: Copper-Clad Aluminium (CCA), 26 AWG
• Connector type: RJ45 male — both ends
• Maximum frequency: 250 MHz
• Maximum data rate: up to 10,000 Mbps (10 Gbps) in supported environments
• Jacket material and colour: PVC, blue
• Outer diameter: 5.4 mm

How to use

Plug one RJ45 connector into the network port of your device and the other into the switch, router or patch panel port. Ensure connectors are fully inserted until the latch clicks to establish a reliable connection. Route the cable to avoid tight bends and mechanical stress; keep it away from strong electromagnetic sources to reduce potential interference. For permanent installations, use this patch cord for patching and short links rather than long permanent runs.

Usage recommendations

Use this LANBERG Cat6 patch cord for desktop connections, patch panels and short interconnects where Cat6 performance is required. Avoid deploying CCA-based cables in long backbone runs or where guaranteed full copper conductivity is required by specific equipment or warranty terms. For optimal performance, maintain bend radii greater than four times the cable diameter and avoid placing the cable parallel to high-voltage power lines.