Patchcord LANBERG Category 6 UTP LSZH copper 20 m red, Fluke Passed

The LANBERG Category 6 UTP LSZH patchcord is a 20 m red Ethernet cable designed for structured network connections. It uses four unshielded twisted pairs with copper conductors and a low smoke zero halogen (LSZH) outer jacket. The cable meets Category 6 performance requirements and has been verified with Fluke testing tools (Fluke Passed), making it suitable for high-speed Ethernet links and standardized patching in data centres, server rooms and office LAN environments where a visible colour is required for cable identification.

Advantages

This Cat6 patchcord provides consistent signal performance for 1000BASE-T and other Ethernet applications within the Cat6 specification. The copper conductors deliver reliable conductivity while the UTP construction supports standard installation practices in patch panels and wall outlets. The LSZH jacket reduces toxic fumes and dense smoke in case of fire, improving safety in enclosed or public spaces. Fluke Passed testing confirms continuity, pair integrity and performance compliance with accepted test procedures.

Suitable for

• Patch panels and switch-to-switch or switch-to-server connections in data centres and server rooms
• Office LAN wiring where colour-coded cabling simplifies identification and troubleshooting
• Temporary or permanent Ethernet links in equipment racks and communication closets

Key specifications

• Category: Cat6 (unshielded twisted pair)
• Length: 20 m
• Conductor: copper
• Jacket type: LSZH (low smoke zero halogen)
• Colour: red
• Performance verification: Fluke Passed
• Connector type: RJ45 (8P8C) terminated

How to use

Connect one RJ45 connector to the network switch, router or patch panel port and the other to the target device or corresponding patch panel port. Route the patchcord along cable management paths to avoid sharp bends; maintain the recommended bend radius for Cat6 cabling to preserve signal integrity. Ensure connectors are fully inserted until a click is felt and verify link status on network devices. For longer installations combine with properly rated infrastructure and follow local wiring standards.

Usage recommendations

Use the red colour to mark specific circuits or service types for easier identification during maintenance. Avoid installing this patchcord alongside high-voltage power lines to minimize electromagnetic interference, and replace any cable showing visible damage to the jacket or connectors. For installations requiring higher shielding or extended performance, consider shielded Category 6A solutions.