SFP Fiber Optic Transceiver Lanview MO-UF-MM-1G 1000 Mbit/s LC 850 nm

Lanview MO-UF-MM-1G is an SFP fiber optic transceiver designed for short-range multimode fiber links. It supports a 1000 Mbit/s data rate over an LC connector using an 850 nm wavelength and follows MSA interoperability guidelines. The module is compatible with Ubiquiti UF-MM-1G devices and other SFP ports that accept MSA-compliant transceivers, providing a compact form factor suitable for Gigabit Ethernet uplinks and local fiber connections.

Advantages

The transceiver delivers Gigabit performance with a standard LC interface and 850 nm multimode operation, enabling reliable short-distance fiber connectivity. Its SFP form factor and MSA compliance make it interchangeable with a wide range of network equipment that supports SFP modules. The compact dimensions and low weight make it easy to install and handle in rack or switch environments.

Suitable for

• Short-range multimode Gigabit Ethernet links
• Fiber uplinks between switches in the same building or data center
• Replacing or expanding SFP ports on compatible network devices
• Use with Ubiquiti devices that accept UF-MM-1G compatible transceivers

When it may not be suitable

This module is intended for multimode fiber and short-range links; it is not suitable for single-mode long-distance connections. It also requires a device with an SFP slot that accepts MSA-compliant transceivers and may not function with equipment that enforces vendor-specific firmware or locked ports.

Key specifications

• Form factor: SFP
• Interface type: LC
• Maximum data transfer rate: 1000 Mbit/s
• Wavelength: 850 nm (multimode)
• MSA-compliant interoperability
• Typical module dimensions: approximately 12 mm × 56 mm × 8.5 mm
• Weight: 0.02 kg

How to use

Power off or follow hot-swap procedures recommended by your network equipment vendor, insert the SFP transceiver into an available SFP port until it seats firmly, and connect a suitable multimode LC duplex fiber patch cable. After installation, verify link status and network settings on the host device to confirm Gigabit connectivity. Follow any vendor-specific instructions for enabling third-party transceivers if required by the equipment.

What to consider before purchase

• Ensure the target device has an SFP slot and supports MSA-compliant transceivers.
• Confirm multimode fiber infrastructure and LC connectors are in use on both ends of the link.
• Verify required link distance is within multimode/850 nm limits for reliable operation.
• Check compatibility policies of your network equipment vendor regarding third-party SFP modules.

Usage recommendations

Use certified multimode LC patch cables in good condition, keep fiber connectors clean, and follow ESD-safe handling procedures during installation. Test the link after insertion and monitor signal and error counters to ensure stable Gigabit performance.