Leave your address - as soon as the price of the product goes down, you'll know about it right away
Coaxial cable LIBOX PCC102GEL-20 — gel-filled, 20 m
Coaxial cable LIBOX PCC102GEL-20 — gel-filled, 20 m
In cart {{totalProductsCount}} item(s)
Your cart is empty
Coaxial cable LIBOX PCC102GEL-20 — gel-filled, 20 m
Leave your address - as soon as the price of the product goes down, you'll know about it right away
Coaxial cable LIBOX PCC102GEL-20 — gel-filled, 20 m
Coaxial cable LIBOX PCC102GEL-20 — gel-filled, 20 m
Coaxial cable LIBOX PCC102GEL-20 — gel-filled, 20 m is a 20-metre coaxial cable designed for reliable radio-frequency signal transmission in TV, satellite and CCTV installations. The gel-filled dielectric and sealed outer jacket provide protection against moisture ingress, making this cable suitable for outdoor antenna feeds, short direct burial in conduits and exposed runs where water resistance and stable signal continuity are required.
The gel filling inside the cable core prevents water migration and corrosion of the conductor and shielding layers, increasing long-term signal stability in damp or wet environments. The construction offers consistent characteristic impedance and low loss across typical TV and CCTV frequency ranges, while the outer sheath resists weathering during external installation. The 20 m length covers common installation distances without additional splices, reducing potential signal loss points.
Strip the outer jacket and dielectric according to the connector manufacturer’s instructions, taking care not to disturb the gel more than necessary. Install suitable RF connectors (F-type, BNC or other compatible connectors) and secure them with proper crimping or compression tools. Route the cable along the planned run, avoid sharp bends and excessive tension, and seal any outdoor terminations or junctions with weatherproofing tape or boots. For burial in conduit, ensure the conduit is dry and free of debris before pulling the cable through.
Use connectors and weatherproofing accessories rated for outdoor RF applications. For runs longer than 20 m or where minimal signal loss is critical, consider using a low-loss coaxial type specified for the required frequency band or add a powered amplifier at the signal source. Store cut ends upright during installation to minimize gel contamination and clean connector surfaces before final assembly.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}