Power outlet MACLEAN MCE215 German version with 1×16A and 2×2.5A protected sockets

The MACLEAN MCE215 German version is a wall-mounted power outlet combining one 16A protected socket and two 2.5A protected sockets in a single unit. It is intended for fixed installation in domestic or light commercial spaces, delivering a higher-current feed for heavier appliances through the 16A socket while providing two low-current sockets for devices requiring limited current. The unit follows the German socket format and integrates protective measures for each outlet to help maintain safe operation under typical household and small-workspace conditions.

Advantages

This combined outlet reduces the need for multiple separate sockets by integrating a high-current 16A point alongside two low-current 2.5A points in one faceplate. Individual protection for each socket improves safety and simplifies wiring layout during installation. The German format and compact design allow straightforward replacement of standard in-wall outlets without altering existing electrical architecture. The product is suitable for environments where mixed-power supply is required on a single wall position.

Suitable for

• Supplying a single high-power appliance (e.g., oven, water heater, or power tool) from the 16A socket
• Powering low-current equipment such as phone chargers, LED lighting, or small kitchen appliances via the 2.5A sockets
• Workshops and utility rooms where both heavy and light loads are used in close proximity
• Office setups requiring a dedicated higher-current point plus auxiliary low-current outlets
• Kitchens that need an integrated solution for mixed appliance power requirements

Key specifications

• Socket configuration: one 16A protected socket and two 2.5A protected sockets
• Format: German standard wall outlet design suitable for in-wall installation
• Protection: individual protected outputs for each socket to limit fault impact
• Installation type: fixed in-wall mounting for domestic and light commercial use
• Finish: flush-mounted faceplate designed for standard wall boxes

How to use

Turn off power at the circuit breaker before beginning installation. Mount the outlet into a compatible in-wall box and make wiring connections according to local electrical codes: connect the phase, neutral and protective earth conductors to their corresponding terminals. Secure the unit to the wall box and attach the cover plate. After installation, restore power and test each socket with appropriate loads: verify the 16A socket supplies higher-current appliances and confirm the 2.5A sockets operate correctly with low-current devices. If unsure about wiring or local compliance, use a qualified electrician to install and verify connections.

Usage recommendations

Use the 16A socket for appliances rated at or below the socket’s current capacity and reserve the 2.5A sockets for chargers and small devices. Avoid overloading a single circuit by distributing high-power loads appropriately and following local electrical regulations. Regularly check for secure connections and visible signs of wear; replace the outlet if any damage or unusual heating is observed.