Swing gate drive Nice Toona TO4024 24 V, 120 W, 0.016 m/s, 95 cycles/h

The Nice Toona TO4024 is a swing gate drive with a 24 V DC motor designed for automated single- or double-leaf gates. It provides controlled movement at a travel speed of approximately 0.016 m/s and is intended for residential and light-commercial installations requiring moderate duty cycles. With 120 W motor power and support for up to 95 cycles per hour, the unit integrates with common access control accessories and safety devices and can be configured for battery-backed low-voltage operation.

Advantages

The 24 V motor delivers consistent low-voltage performance with smoother starts and stops compared with direct AC drives, which reduces mechanical stress on hinges and linkages. Low-voltage operation allows safe integration of battery backup for continued function during power interruptions. The drive accepts standard control inputs and safety sensors and offers adjustable opening speed and force so installers can tune operation to gate weight and site conditions.

Suitable for

• Residential single or double swing gates with moderate weight
• Light-commercial entrances with regular daily cycles
• Retrofit projects requiring low-voltage automation and battery backup
• Installations needing integration with access control, intercom or safety sensors

Key specifications

• Motor voltage: 24 V DC for low-voltage operation
• Motor power: 120 W for moderate gate loads
• Travel speed: approximately 0.016 m/s for controlled movement
• Rated duty: up to 95 cycles per hour suitable for residential and light-commercial use
• Adjustable opening speed and force to match gate weight and dimensions
• Compatibility with standard safety devices such as photocells and safety edges
• Provision for battery backup to allow operation during mains failure
• Mechanical construction suitable for outdoor gate mounting

How to use

Install the drive units on gate posts or pillars following the manufacturer’s alignment and anchoring instructions. Secure gate pivot points and verify there is no excessive play. Connect the 24 V power supply, control wiring and safety device circuits, and install an optional battery backup module if required. Adjust opening angle, speed and force parameters on the control unit to suit gate geometry, then run multiple open/close cycles while monitoring safety sensors and obstacle detection to confirm correct and safe operation.

Usage recommendations

Perform periodic inspections of mounting hardware, hinges and electrical connections, and maintain accessory wiring and control firmware according to the manufacturer’s guidelines. Use compatible safety sensors and comply with local regulations for automated gates. For battery-backed systems, select an appropriate capacity battery and verify its charge state regularly to ensure operation during power outages.