SFP+ transceiver module No name EX-SFP-10GE-SR-C — 10 Gigabit short-range for multimode fiber

The SFP+ transceiver module No name EX-SFP-10GE-SR-C provides 10 Gigabit Ethernet short-range optical connectivity for multimode fiber. It is designed for insertion into SFP+ ports on compatible switches, routers and network interface cards to enable 10GbE links over short distances in data centers, enterprise LANs and server rooms. The module supports standard 10GbE signaling and is intended for multimode fiber environments where short-range, high-bandwidth links are required.

Advantages

This SFP+ transceiver offers straightforward 10 Gigabit short-range connectivity with a compact hot-pluggable form factor that fits standard SFP+ ports. It enables high-bandwidth uplinks and server connections without requiring major hardware changes, and its multimode fiber operation simplifies cabling within racks and between nearby equipment. The module is suitable for mixed-vendor environments where standard 10GbE optical interfaces are needed.

Suitable for

• Switch-to-switch uplinks in data center racks
• Server-to-switch connections within the same room or floor
• Aggregation links in enterprise LANs over multimode fiber
• Short-distance 10G links between wiring closets

Key specifications

• Interface: SFP+ hot-pluggable transceiver
• Data rate: 10 Gigabit Ethernet
• Optical type: short-range (SR) for multimode fiber
• Wavelength: compatible with short-range multimode fiber transmission
• Form factor: compact SFP+ module suitable for standard SFP+ cages
• Operating environment: designed for typical data center and enterprise indoor use

How to use

Power down the host device if recommended by the equipment manufacturer, then insert the SFP+ transceiver into an available SFP+ port until it seats firmly. Connect multimode fiber patch cables with the appropriate connector type to both ends, ensuring correct polarity and clean connectors. Restore power if the device was powered down; most systems support hot-plug insertion and will auto-detect the module and configure the link at 10GbE if the connected device supports the transceiver. Monitor link status and alarms on the host device to verify successful establishment of the optical link.

Usage recommendations

Use factory-tested multimode fiber patch cords and maintain clean connector endfaces. Verify compatibility with the host equipment and, if necessary, consult switch/router documentation for any required firmware or port settings. For reliable performance, keep multimode cable runs within the recommended distance for short-range 10G optics and avoid excessive bend radii.