No name 2.5m Slim CAT6 Ethernet Cable, UTP, 100W PoE, 28AWG Pure Copper, LSZH, Red, RJ45

Slim CAT6 Ethernet patch cable, 2.5 m length, U/UTP unshielded construction for Gigabit Ethernet up to 1000 Mbit/s. The cable uses 28AWG pure bare copper conductors and supports Power over Ethernet up to 100W. A Low Smoke Zero Halogen (LSZH) jacket reduces smoke and toxic fumes in the event of fire, while a slim 3.6 mm outer diameter and flexible jacket enable routing in high-density installations. Gold-plated RJ45 contacts and a snagless strain-relief design provide secure connections and protection during installation. Each cable is individually tested to meet Category 6 performance requirements for reliable connectivity.

Advantages

The slim profile is approximately 36% thinner than standard Cat6 cables, improving airflow and simplifying cable management in crowded racks and patch panels. Unshielded twisted pair (UTP) construction with 28AWG pure copper conductors provides low resistance and consistent signal transfer. The LSZH jacket reduces the release of smoke and toxic gases in enclosed or poorly ventilated spaces. Snagless connectors and gold-plated contacts reduce the risk of clip damage and maintain a stable mechanical and electrical connection throughout repeated insertions.

Suitable for

• High-density network racks and patch panels where space and airflow are limited
• Gigabit Ethernet connections for switches, routers and networked devices
• Power over Ethernet installations requiring up to 100W (PoE++) for cameras, access points or other PoE endpoints
• Residential or commercial environments where LSZH jacket is preferred for safety

Key specifications

• Length: 2.5 m
• Cable type: Cat6 U/UTP (unshielded twisted pair)
• Conductor: 28AWG pure bare copper, 4 pairs
• Outer diameter: 3.6 mm
• Data rate: supports up to 1000 Mbit/s (Gigabit Ethernet)
• Frequency: up to 250 MHz
• PoE: supports up to 100W (IEEE 802.3bt Type 4 compatible)
• Jacket material: Low Smoke Zero Halogen (LSZH)
• Connectors: RJ45 with 50-micron gold-plated contacts, snagless strain relief
• Tested: individually tested to meet Category 6 performance

How to use

Connect one RJ45 plug to the network device (switch, router, PoE injector or PoE-enabled device) and the other plug to the corresponding port on the destination device. Ensure connectors are fully inserted until the clip locks in place; the snagless design protects the clip during routing. Route the slim cable through cable management channels, patch panels or tight spaces, taking advantage of the reduced diameter and flexibility to minimize bends and maintain signal integrity. Verify link status on connected equipment and confirm PoE power delivery if powering remote devices.

Usage recommendations

To preserve performance, avoid tight sharp bends and keep the cable within recommended bend radius for Cat6. Separate data cabling from high-voltage power lines where possible to reduce interference. For permanent installations in enclosed or public spaces, choose LSZH-sheathed cables for reduced smoke and gas emissions. Test connections after installation and replace cables showing visible damage to jacket or connectors.