Carbon Brush Pair (2 pcs) for TOG5000K Generator — No name, MPN YAP1R611

Replacement carbon brush pair (2 pcs) designed for use with TOG5000K portable generators. These carbon brushes act as wear parts for the generator's electric motor/alternator, maintaining electrical contact between the rotating commutator and the stationary brush holder. Replacing worn brushes helps restore consistent current transfer, reduce sparking at the commutator, and support stable generator performance during extended operation.

Advantages

The carbon brush pair provides direct electrical contact with the commutator using conductive carbon material formulated for low wear and reliable conductivity. Supplied as a matched set of two, the brushes ensure even current distribution across the motor's collector segments. Their compact design fits the brush holder assembly of compatible portable generators and simplifies routine maintenance or repair tasks without the need for machining or adjustments in most installations.

Suitable for

• Routine maintenance of TOG5000K portable generator motors
• Repairing generator alternator commutator wear and restoring electrical contact
• Reducing sparking and electrical noise in the commutator/collector
• Field replacement during service or preparation for extended use

Key specifications

• Set contents: 2 carbon brushes
• Material: conductive carbon/graphite composite suitable for commutator contact
• Application: brushes for generator motor/alternator commutator
• Function: conductive contact element, wear part for current transfer
• Mounting: designed for insertion into standard brush holder assemblies of compatible portable generators

How to use

Switch off the generator and disconnect any power sources and batteries before beginning service. Access the brush holder by removing the appropriate cover or panel according to the TOG5000K service instructions. Remove the old, worn brushes from their holders, inspect the commutator surface for excessive wear or pitting, and clean any debris. Insert the new carbon brushes into the brush holder ensuring correct orientation and secure any retaining springs or clips. Reassemble the cover and perform a no-load run to verify reduced sparking and stable operation.

Usage recommendations

Inspect the brushes periodically and replace them in matched pairs when carbon length is below the manufacturer's minimum service length or when excessive sparking is observed. Avoid operating the generator with heavily worn brushes, and check the commutator for scoring or contamination that may require cleaning or machining for optimal contact.