Engine Mount Bracket for Hedge Trimmer Models TOD55551, TOD61621 (44) — No name

Replacement engine mount bracket compatible with hedge trimmer models TOD55551 and TOD61621 (reference 44). This component secures the engine to the trimmer housing, preserving alignment between the power unit and cutting assembly and helping to reduce vibration transfer during operation. It is intended for repair or maintenance of compatible handheld petrol hedge trimmers and is suited for installation by technicians or experienced DIY users.

Advantages

The bracket is designed to restore correct engine positioning and to minimize mechanical play that can cause uneven cutting or excessive vibration. Made to match the original mounting points and dimensions of the compatible models, it enables efficient reassembly and maintains structural stability of the trimmer. Using a proper replacement mount contributes to longer service life of connected components such as drive shafts, bearings and fasteners.

Suitable for

• Repairing petrol hedge trimmers TOD55551
• Repairing petrol hedge trimmers TOD61621
• Maintenance tasks that require replacing a worn or damaged engine mount
• Service work performed by garden tool technicians or experienced DIYers

Key specifications

• Function: engine-to-housing mounting bracket for handheld petrol hedge trimmers
• Compatibility: designed for specific hedge trimmer models listed by manufacturer reference
• Material: metal construction for load-bearing and vibration damping (manufacturer-specified type)
• Mounting: matched hole pattern and fastening points for direct replacement
• Finish: corrosion-resistant coating to withstand outdoor use and minor exposure to fuel and oils

How to use

Before starting the replacement, ensure the trimmer is switched off, cooled and emptied of fuel as required by the manufacturer’s safety instructions. Remove any covers or ancillary parts that block access to the existing engine mount, then unfasten the mounting bolts and carefully detach the old bracket. Position the new engine mount bracket so that its holes align with the engine and housing mounting points, then install the original fasteners and tighten them to the recommended torque values. Reassemble removed components and check alignment and secure fit before testing the tool at low throttle to verify reduced vibration and correct operation.

Usage recommendations

Use only genuine or correctly spec’d replacement parts and follow the hedge trimmer manufacturer’s torque and service instructions. If mounting points are corroded or damaged, repair or replace those parts before fitting the new bracket. For safety and optimal performance, final tightening and alignment checks should be performed by a qualified technician when in doubt.