UTP Ethernet Cable DomNET 305 m — Cat 6, Unshielded Twisted Pair, OEM DOM6UTP

DomNET OEM Cat 6 UTP cable on a 305 m reel is an unshielded twisted-pair cable designed to support Gigabit Ethernet and structured cabling installations. The continuous 305-meter length on a factory-wound reel facilitates long runs without interruptions and reduces the number of splices or intermediate terminations. This Cat 6 cable is intended for use in LANs, backbone and horizontal cabling, patching closets and data center environments as well as residential networks where Category 6 performance is required.

Advantages

The cable provides Category 6 performance suitable for 1 Gbps Ethernet over standard maximum distances, offering consistent impedance and reduced crosstalk compared with lower-category cables. Being unshielded (UTP), it is lighter and easier to handle during installation, with a flexible jacket that simplifies routing in conduits and cable trays. The 305 m reel format streamlines large deployments and minimizes waste by providing a continuous length for long runs.

Suitable for

• Office LAN horizontal runs and patch panels
• Data center and server room backbone cabling
• Residential gigabit network wiring
• Structured cabling projects requiring Cat 6 performance

Key specifications

• Cable category: Cat 6 (Unshielded Twisted Pair)
• Length: 305 meters on a single reel
• Conductor type: solid copper conductors (4 pairs)
• Impedance: 100 ohm nominal
• Frequency range: up to 250 MHz
• Typical application: Gigabit Ethernet, structured cabling
• Jacket: flexible PVC or similar low-smoke jacket suitable for general installations

How to use

Measure and plan cable runs according to site layout and structured cabling standards, allowing for vertical and horizontal pathways, patch panels and termination points. Pull the cable from the reel carefully to avoid twists and kinks, maintain bend-radius limits and avoid excessive pulling tension. Terminate each pair using appropriate Cat 6 RJ45 connectors or punch-down keystone jacks following the chosen wiring standard (T568A or T568B). Test each completed link with a cable tester to verify continuity, pair mapping, and performance parameters such as attenuation and near-end crosstalk (NEXT).

Lietojuma ieteikumi

For reliable Cat 6 performance, keep cable runs under recommended maximum distance for Ethernet links, separate UTP runs from strong electrical sources to reduce interference, and use proper grounding practices at patch panels and equipment racks where applicable.