Air compressor accessory Pansam A533081 — inlet pressure max 12 bar, 1 pc

The Pansam air compressor accessory A533081 is a single-piece component intended for installation in compressor systems that require an inlet pressure rating up to 12 bar. Supplied as one unit, this accessory is designed for routine maintenance, replacement of worn parts or modest upgrades where compatibility with a 12 bar inlet is needed. The component is compact and intended to integrate into existing compressor plumbing or assembly points that accept standard compressor fittings.

Advantages

This accessory provides a clearly specified maximum inlet pressure of 12 bar, allowing technicians to match component ratings with system requirements. Supplied as a single piece, it simplifies inventory management for minor repairs and single-point replacements. The design is intended for straightforward installation into compatible compressor systems, helping to restore or maintain safe operating pressures without requiring a full system overhaul.

Suitable for

• Routine maintenance and periodic replacement of compressor inlet components
• Repair of small leaks or worn fittings in compressed air lines
• Upgrading inlet parts when system operating pressure does not exceed 12 bar
• Single-unit spare part stocking for workshop or service vehicles

Key specifications

• Maximum inlet pressure: 12 bar
• Quantity in pack: 1 piece
• Intended use: compressor inlet component for integration with compatible fittings
• Application: maintenance, replacement, or minor upgrades of compressor inlet system

How to use

Before installation, verify that the system is depressurised and isolated from power. Confirm compatibility of connections and thread types with the existing compressor plumbing. Replace the worn or defective inlet component by disconnecting the inlet line, removing the old part and fitting the Pansam accessory in the same orientation, ensuring tight seals and correct torque on threaded joints. After installation, gradually repressurise the system while checking for leaks and correct operation at pressures up to the rated 12 bar.

Usage recommendations

Use this accessory only in systems where the working pressure does not exceed 12 bar. Regularly inspect fittings and seals after installation and perform leak tests at operating pressure. If in doubt about compatibility with specific compressor models or piping, consult technical documentation or a qualified service technician.