SFP+ Single-Mode Transceiver PULSAR GBIC-206 10Gbps 1xLC 20km

PULSAR GBIC-206 is an SFP+ single-mode optical transceiver module that delivers 10 Gbps data transmission over a single LC connector with an operating reach of up to 20 km. Designed for fiber-optic network links, this module is suitable for deployment in enterprise and metro networks where reliable high-speed uplinks and long-distance connections between switches, routers or media converters are required.

Advantages

The transceiver supports a 10 Gbps line rate in a compact SFP+ form factor, enabling high-density port configurations while maintaining low power consumption. Its single-mode design and LC connector provide stable performance for long-reach links up to 20 km over standard single-mode fiber. The module is compatible with common SFP+ ports, facilitating straightforward installation and replacement in active network equipment.

Suitable for

• High-speed uplink connections between switches and routers
• Long-distance links within campus and metro networks
• Aggregation ports and data center interconnects
• Replacement or spare module inventory for network maintenance

Key specifications

• Data rate: 10 Gbps
• Fiber type: single-mode fiber (SMF)
• Connector: 1 x LC duplex
• Maximum reach: up to 20 km
• Form factor: SFP+
• Typical application: optical uplinks and long-reach links

How to use

Install the transceiver into an available SFP+ port on compatible network equipment until it clicks into place, then connect a single-mode LC fiber patch cable between network devices. Ensure that transceiver end faces are clean before insertion to avoid signal degradation. After physical installation, verify link status and configuration on the network device; set appropriate interface speed and duplex settings if required by the platform. For in-service replacement, perform hot-swap procedures supported by the equipment and monitor link re-establishment.

Usage recommendations

Use certified single-mode LC patch cables and adhere to standard fiber handling practices, including cleaning connectors and protecting transceiver openings with dust caps when not connected. Verify compatibility with your network hardware and firmware versions before deployment to ensure optimal performance.