Coaxial cable Rangeful HF240 50 Ω 10 m — SMA (male) to N (male)

Coaxial cable Rangeful HF240 50 Ω 10 m with SMA (male) to N (male) connectors is a flexible RF cable intended for reliable 50-ohm signal transmission. The 10 m length provides extended reach between devices while preserving impedance matching for radio, microwave and test applications. One end of the cable terminates in an SMA male connector suited for compact equipment and measurement adapters, while the opposite end uses a robust N male connector for outdoor and rack-mounted devices.

Advantages

This RF cable combines low-loss coaxial construction with durable SMA and N male terminations to deliver stable signal transfer across a wide frequency range. Its flexible jacket and controlled impedance reduce signal reflections and simplify routing in installations and test setups. The contrasting connectors make the cable compatible with both compact handheld equipment and larger RF systems without additional adapters.

Suitable for

• Connecting radios, transceivers and handheld devices with SMA interfaces to systems using N connectors
• Linking antennas and masts to receivers, repeaters or amplifiers where 50 Ω matching is required
• Laboratory and field measurements with spectrum analyzers, network analyzers and signal generators
• Temporary or semi-permanent installations requiring a 10 m flexible RF lead

Key specifications

• Characteristic impedance: 50 Ω
• Cable length: 10 m
• Connector A: SMA male
• Connector B: N male
• Cable type: low-loss coaxial for RF/microwave applications
• Typical use: RF signal transmission, antenna connections, test equipment links

How to use

Connect the SMA male end to the SMA female port on the transceiver, measurement adapter or handheld device, and secure the N male end to the N female connector on the antenna, repeater, amplifier or test instrument. Ensure connectors are clean and free of debris before mating, and tighten to the manufacturer's recommended torque when applicable to avoid damage and ensure consistent electrical contact. Route the cable to avoid sharp bends, kinks or compression that could alter impedance.

Usage recommendations

For best performance, avoid excessive bending radii and protect connector interfaces from moisture and mechanical stress. Use appropriate connector dust caps when the cable is stored or not connected. When making repeated connections in a test environment, periodically inspect the cable and connectors for wear and replace if corrosion or significant degradation is observed.