Coaxial cable Rangeful HF240T-NMH-NF-15 — N male to N female twin, 15 m, 50 Ω

Rangeful HF240T-NMH-NF-15 is a twin coaxial cable assembly with N male to N female connectors, 15 meters in length and a characteristic impedance of 50 Ω. It is intended for RF signal transmission where two matched coax lines are needed between equipment with N-type interfaces; common applications include antenna feeds, radio systems, and test setups that require reduced reflections and consistent connectivity.

Advantages

The twin configuration integrates two matched coaxial lines in a single cable sheath to simplify routing and maintain consistent electrical length between channels. N-type connectors provide robust mechanical mating and good performance at RF frequencies. The 50 Ω impedance supports standard radio-frequency equipment and helps minimize mismatch losses and standing waves when properly installed.

Suitable for

• Antenna feeding where dual lines or diversity connections are required
• Radio and wireless system interconnections with N-type interfaces
• Laboratory and test equipment setups requiring matched cable pairs
• Base station components and repeater links with 50 Ω systems

Key specifications

• Cable type: twin coaxial assembly with two conductors in one outer jacket
• Connector types: N male to N female on each respective end
• Length: 15 m
• Characteristic impedance: 50 Ω
• Application: RF signal transmission for antennas, radio systems and test equipment

How to use

Verify that both connected devices accept N-type connectors and that a 50 Ω interface is appropriate for the equipment. Route the twin cable to avoid sharp bends and close proximity to high-power conductors to reduce interference. Secure connectors by hand-tightening and then apply the recommended torque for N-type connectors if a torque wrench is available; ensure proper mating alignment to avoid damaging the connector threads. When used in test setups, document cable lengths and connections to maintain traceability and comparable measurements.

Usage recommendations

Store the cable on a suitable reel or coil with a radius that prevents crushing the jacket and inner conductors. Avoid repeated flexing near the connector ends; inspect connectors periodically for corrosion or deformation. For outdoor or permanent installations, complement the cable with appropriate weatherproofing at the connector interfaces and verify system SWR after installation to confirm acceptable return loss.