Coaxial Cable N Male to N Female Rangeful HF400 Flexible 50 Ω 1 m

Rangeful HF400 Flexible 50 Ω coaxial cable with an N male connector on one end and an N female connector on the other. This 1 m RF cable is built on HF400 construction to combine mechanical flexibility with effective shielding, intended for use in 50 Ω systems. The cable is suited for signal routing between antennas, test equipment, transceivers and communications devices where a short, flexible interconnect is required.

Advantages

The HF400 construction delivers a balance of flexibility and stable electrical performance, minimizing handling losses and preserving signal integrity across the 1 m length. N-type connectors provide threaded, weather-resistant coupling and solid mechanical contact for repeated mating cycles. The 50 Ω impedance match reduces reflections when used with compatible RF equipment, and the flexible jacket eases routing in crowded installation spaces.

Suitable for

• Connecting antennas to transceivers and amplifiers
• Interfacing test and measurement instruments
• Short RF jumper runs in base stations and repeaters
• Laboratory setups and prototype benches

Key specifications

• Nominal impedance: 50 Ω
• Length: 1 m
• Connector types: N male to N female (threaded)
• Cable construction: HF400-style flexible coax
• Typical use: RF signal transmission and interconnects

How to use

Connect the N male end to the corresponding N female port on your device and tighten the threaded coupling by hand until snug; avoid overtightening with tools to prevent damage to the connector. Attach the N female end to the mating N male connector on the other device in the same manner. Route the cable to avoid sharp bends and prolonged compression points; maintain bend radii appropriate for flexible HF400 cable to preserve performance. Inspect connectors before use for cleanliness and secure seating to ensure low-loss connections.

Usage recommendations

Use this 1 m Rangeful HF400 flexible coax as a short jumper within 50 Ω RF systems. For outdoor or permanent installations, ensure connectors are protected from moisture with suitable sealing or weatherproofing. Avoid repeated tight bending near the connector assemblies and periodically check connectors for corrosion or wear when used in demanding environments.