Coaxial cable Rangeful HF400-RPSM-NM-1 1 m, 50 Ω, full copper, flexible

Rangeful HF400-RPSM-NM-1 is a 1 m coaxial cable with 50 Ω characteristic impedance, constructed with full copper conductors and a flexible outer jacket. The cable is terminated with an RPSM connector on one end and an NM connector on the other, designed for RF signal connections between equipment and antennas or test instruments. Its flexible build allows routing in confined spaces while maintaining low insertion loss for short RF runs and laboratory setups.

Advantages

The full copper center conductor and braid provide consistent conductivity and contact quality across the frequency band supported by the cable. Flexibility reduces stress on connectors and simplifies installation in tight or curved routing paths. The 50 Ω impedance ensures compatibility with standard RF equipment, minimizing reflections and providing reliable signal transfer for short distances. Durable jacket material protects the cable from mechanical wear during handling and repeated connect/disconnect cycles.

Suitable for

• Antenna connections for routers, access points and small base stations
• Lab test setups and RF measurement connections
• Short RF link extensions and patching between devices
• Portable or temporary installations requiring quick routing

Key specifications

• Length: 1 meter
• Impedance: 50 Ω
• Conductor: full copper center and copper braid
• Connectors: RPSM to NM
• Construction: flexible coaxial design with protective outer jacket
• Typical use: RF signal transmission for short runs

How to use

Inspect both the RPSM and NM connectors for cleanliness and secure mating surfaces before installation. Align the connectors and hand-tighten or engage according to the connector type until a firm mechanical connection is achieved; avoid over‑torquing. Route the cable to avoid sharp bends, kinks or undue mechanical strain and keep it away from sources of strong electromagnetic interference when possible. For test bench use, lay the cable to minimize loop area and maintain consistent connector orientation to facilitate repeatable measurements.

Usage recommendations

Use the cable for short-distance RF links and lab connections where low loss and flexibility are required. Replace the cable if the jacket or connectors show visible damage, corrosion or if signal performance degrades. Store coiled without tight loops to preserve flexibility and avoid permanent deformation.