Coaxial cable Rangeful HF400-RPSM-NM-10 10 m, full copper, 50 Ω, RPSM–NM connectors

The Rangeful HF400-RPSM-NM-10 is a 10 m coaxial cable with full copper conductors and a characteristic impedance of 50 Ω. Engineered for RF signal transmission, the cable is fitted with an RPSM connector on one end and an NM connector on the other, providing compatibility with a range of antenna systems, radio equipment and test instruments. The cable features a flexible outer jacket and shielding designed to minimise signal loss and external interference while simplifying installation and replacement in existing setups.

Advantages

The full copper conductors ensure consistent conductivity and lower insertion loss compared with plated alternatives. The 50 Ω impedance matches common RF devices and antenna feeds to maintain signal integrity. RPSM and NM connectors are standard types that allow straightforward connection to many transceivers, antennas and measurement devices. The flexible jacket facilitates routing in confined spaces and reduces mechanical strain during installation.

Suitable for

• Antenna connections for radio transceivers and receivers
• Laboratory and field test setups for RF measurements
• Temporary or permanent links between radio equipment and external antennas
• Replacement of existing coaxial leads where 50 Ω impedance and RPSM–NM connectors are required

Key specifications

• Cable length: 10 m
• Conductor material: full copper
• Characteristic impedance: 50 Ω
• Connector types: RPSM (one end) and NM (other end)
• Outer jacket: flexible design for ease of routing

How to use

Inspect connectors and cable for visible damage before use. Connect the RPSM end and the NM end to the corresponding equipment or antenna by aligning and securing each connector according to the device manufacturer’s instructions. Route the cable to avoid sharp bends, crushing, or exposure to excessive heat; secure with straps or clips as needed. For testing applications, ensure proper termination and grounding of the test setup to avoid measurement errors.

Usage recommendations

Where possible, avoid tight bends near the connector ends and maintain bending radii recommended for coaxial cables. Periodically check connectors for corrosion or loose fittings and replace the cable if any mechanical or electrical degradation is observed.