Coaxial cable Rangeful RP-TNC male to RP-TNC female 10 m LMR400 UF UltraFlex

Coaxial cable Rangeful RP-TNC male to RP-TNC female 10 m LMR400 UF UltraFlex is a 10-metre RF cable designed for low-loss signal transmission between devices with reverse polarity TNC interfaces. Constructed on LMR400 UF UltraFlex dielectric and jacket technology, the cable combines flexibility and mechanical durability to suit both indoor and outdoor antenna installations, Wi‑Fi access points, cellular equipment and RF test setups where a heavier-duty, low-loss coax is required.

Advantages

This RP-TNC to RP-TNC cable delivers reduced insertion loss typical of LMR400 construction while offering improved bendability thanks to UltraFlex formulation, making routing and installation easier in confined spaces. The reverse polarity TNC connectors provide secure mating with RP-TNC ports and are assembled to maintain consistent electrical performance. The outer jacket is engineered for abrasion resistance and UV stability appropriate for temporary or permanent external runs when protected from extreme mechanical abuse.

Suitable for

• Connecting Wi‑Fi access points to external antennas
• Cellular and LTE antenna extensions in indoor/outdoor installations
• RF test and measurement setups requiring RP-TNC interfaces
• Point-to-point radio links and repeater connections

Key specifications

• Cable type: LMR400 UF UltraFlex coaxial
• Connector configuration: RP-TNC male to RP-TNC female
• Length: 10 m
• Characteristic impedance: 50 Ω
• Typical attenuation: low-loss profile suitable for VHF/UHF and cellular bands (depends on frequency)
• Construction: flexible jacket with braid and foil shielding

How to use

Route the 10 m RP-TNC cable between devices so connectors align without excessive bending at the connector ends. Hand-tighten the RP-TNC coupling nut until snug; avoid using pliers to prevent over-torquing. Position cable runs to minimise sharp bends and kinks; when used outdoors, secure the cable with UV-resistant clips or ties and provide strain relief at connectors. Verify continuity and signal loss with appropriate RF test equipment after installation.

Usage recommendations

For optimal long-term performance, avoid repeated flexing at the connector termination, keep the cable clear of high-traffic areas to prevent abrasion, and if used outdoors leave ends protected with suitable weatherproofing boots or tape. Select this LMR400 UF UltraFlex cable where a balance of low loss and improved flexibility is required for RP-TNC systems.